I have enabled comp-lwz within the transform set for a VPN, router is a 7204 VXR with a SAM, the following failures are causing me concern, should I be? #pkts encaps: 17372076, #pkts encrypt: 17372076, #pkts digest 17372076 #pkts decaps: 14933136...
trying to setup in a test environment on a 6506 l3 between vlan 2 10.20.2.0 /24 and vlan 3 10.20.3.0 /24this what i didsession 15int vlan 2ip address 10.20.2.254 255.255.255.0no shutint vlan 3ip address 10.20.3.254 255.255.255.0no shutrouter igrp 100...
I did a quick search and couldn't find anything that might address this potential design option.Looking at the following setup;Two 831 Ethernet routers at the remote site, each connected to a different DSL/Cable provider (for redundancy). Each 831 is...
Hello,I have a cisco 2x7609 equipped with SUP-2 module. VLANs on both nodes are configured with HSRP. Example of my configuration on node 1:interface Vlan704 description ip address 10.20.30.1 255.255.255.224 no ip redirects no ip unreachables no ip ...
Dear all,I would like to upgrade my router 1751 with 12.2 IOS IP Base to 12.3 IOS IP base. The router is under warranty.somebody Plz tell me how to accomplish this task....?Regards,R.Rajaraman
I am using Cisco 2610XM with IOS version 12.2(8) and a Cat 2950 Switch, Switch has two VLANs configured now i want to make inter-vlan routing through 2610XMBut when i create fastethernet subinterfaces and tried to use encapsulation dot1q vlan ID comm...
Hello,Here is my problem: I have plenty of 48 ports switches (IOS, CatOS), and they all have been cabled: since a long time, as soon as a new connection was needed, a new port was used. Then, many of the ports are now unused, but we don't know which ...
Hi...We have 60 vlans in our network. We use 6509 as a core switch and all edge switches are connected directly to it.We would be receiving a vidoeconferencing software in 3 months time where 60 out of 2000 employees will be using it.- What is recomm...
here is the output my a cat switch.South_Korea(config-if)#switchport trunk encapsulation ?dot1q Interface uses only 802.1q trunking encapsulation when trunkingisl Interface uses only ISL trunking encapsulation when trunkingI wonder why call "dot1...
I have 24 switches (mixture of 3524/48 and 2950T/G) in two clusters all hanging off a core catalyst 4006 with SupII running catOS. I am aware of the problem with clustering through this device as it is CDP enabled but does not support clustering so w...
Hi, I have a few stacked cisco 3750 switch. If I upgrade the IOS with .bin or .tar file format with one of the switch via remote CLI telnet. How to transfer the IOS to other switch?Is that posiable to telnet to different unit (Stacked switch) remotel...
Hi all,Appreciate if someone could shed some light on this. When configuring the MTU on an interface using the "mtu" command, does the specified MTU serve as a default for all L3 MTUs or is that supposed to be an absolute maximum MTU ? E.g. can we ...
