Other Network Architecture Subjects

My 7204 LNS shares a L2 Vlan (vl40) with my pix's dmz2 intf.PPPoE/l2tp clients connect via LAC router to 7204 LNS.Clients are on the same IP subnet than pix dmz2.So traffic from clients has not to be routed but only bridged.Is it possible :- pix dmz2...

I have a Cisco 6905 with 10/100/1000 blades that are connected to some large database servers. About once a month I need to reboot this device because of very slow network responce time. Is there anything I can check on this device to see what could ...

Hidoes anybody have config samples of implementation of NAt traversal (ipv4 to ipv6) ?TksRic

We have had a number of issues lately on our DWDM circuit and every time the circuit goes down we need to physically reset the gbic (Slide in and out) to enable the link to recover. In most instances it is only a blip on the DWDM however, this manu...

I have a customer with some older Catalyst 4003 chassis with Supervisor1's and some 4006 with Supervisor2's. Each of the switches has the WS-X4232-L3 services module and this is being used to connect to a 6500 Core using /30 links. From a classic n...

I would like to know which cable I need to used between LRE 48 Post Splitter, PBX and CPE.Thanks

Our configuration : 1 x 2950G-48 with uplink 1 Gb/sThere are 3 vlans.--> uplink is configure as a trunk.We want that vlan3 don't use more than 100 Mb/s in the uplink.Is it possible to do this ?Thanks for your help,LB.

Dear support, many thanks for the support I have received already on this matter, but have one small question I need to answer.I have recently implemented QoS between two 3550-48 EMI switches. All appears fine on the switches (i.e. traffic is showing...

Hi all,As far as I understand..DR/BDR Election takes place using hello protocol and is based on the interface priority ..and in case of a tie ..the higher Router-id wins and becomes DR. In case DR goes down..the BDR takes over as DR and another route...

HelloHave installed Cisco Works SNMS. Now we have two different kinds of Cat4500. One with a SupII and the other with SupIV. Our customer would like to configure the vlans of a port on each devices. On the Cat4500 with SupII it works (CatOS). But on ...

Can anyone guide me on how to use the dnld command in rommon mode..? I really suspect that my recently acquired flash memory simms are damaged, because after doing a xmodem download (after 40 long minutes at 115200 bps), the systems shows:Erasing fla...

Do packets generated by the router undergo NAT? If yes, i dont want this to happen.how can i do that? debug ip nat is given below:interface Vlan2 mtu 9216 ip address 2.2.2.1 255.255.255.0 no ip redirects ip nat inside ip pim sparse-dense-modeinterfac...

Hello,Should i set up a pix501 for two lans ?I mean I have today a pix (192.168.42.40) on a lan (192.168.42.x), ok, working fine.I wanna add a new lan 192.168.0.x, can I use same pix with a kind of alias or so, i would like to access this pix with 19...