Other Network Architecture Subjects

Hi all,Need some help on this one,when i try to generte and mail a report it gives me an errors, this is what i do,RME-configuraion Management -Network ShowCommandd-Immediate Execution I select a device and run a SH ver and i try to email this report...

Hi,Trying to apply access-list 140 onto an interface.Eachtime I try I get "% Invalid access list name."(config-if)#ip access-group 140 in% Invalid access list name.When I try the same command but use "Out" the command works of course my ACL needs to ...

Dear Sir, In switch ,every ports has different MAC address or one combine MAC address of switch.Is this true? When we talk about switch'MAC address in STP calculations. Which MAC address STP take either one of the port's MAC address in switch...

How does this rule apply to Gigabit network? Sorry, just trying to get a thorough understanding on Gigastack GBICs. If you cascade 9 switches how does that work along with the 5-4-3 rule? Thanks.Alan

Hi,We are unable to grab the cpu utilization for the above switches. We have no problem on Cat6500 and Cat4500. Is there any issue with these model? We had tried using various oid on the mrtg but still cant grab it. Any helps?Thx

If GLBP tracks an interface, and the priority changes because an interface goes down, the secondary router takes over as AVF, but it doesn't take over the active state of all the MAC addresses unless the other router goes away. This means that one ro...

I see how to go into the dbreader by logging in with admin rights, accessing http://works.noc.dc.gov:1741/dbreader/dbreader.html, logging in as dba, putting the password in and going to the RME db. Does anyone know how to be able to copy this databa...

Cisco Configuration Tool states that 3000W AC Power Supplies installed into C6509 chassis are incompatible with SUP1-MSFC2. When I try 2500W AC Power Supplies the configuration is OK. What is the reason for this incompatibility? Is that an error in t...

Hi all,I've a problem with my backup router. This router have BGP configured and several static routes. My problem is, that facing a peer closing the router choose the static route (with high administrative distance, 210) and when the peer is back t...

Is a MIB some kind of script/macro? Thanks.Alan

I have two local routers each with a BGP neighbor relationship with a different service provider. Each SP has a neighbor adjacency with a router at one of my remote sites (the same site). When one of the links fails BGP routes across the other SP net...

I´m trying to reserve some modem lines in a AS5300 to be occupied by specific phone numbers, Is it possible to do this using a E1-R2 connection to the PSTN? (I know that this can be done with ISDN using the dialer caller command in the interface dial...

I need big help for this, coz I couldnt find any documentation relate to my situation. We are using EIGRP.Location 1 has ONE T3 and 2 T1 to Location 2, then Location 2 has ONE T3 and 2 T1 to Location 3.Location 1: 7206 VXR (ONE T3 and 2 T1 to Locati...

Hi,I am suspecting a potential network problem on one my switch port, but when I do a “Show interfaceslot/port” the results are pretty good at the exeption of the “input errors”See results below:"Last input never, output never, output hang never Last...

Hi all,I have a Catalyst 6509 and a 3524XL(12.0(5.3)WC(1).They are conneted with each other through TRUNK (ISL) .The Cat3524 have two Vlans .Default Vlan is for Management. and the other is for usersI applyed an ACL on vlan 1 to block spoofing IP add...