Other Network Architecture Subjects

We are planning to dual home 3 separate routers ( WAN, Internet,  and Replication- circuits) into our current pair of 5596's that exist at our newly built second data center which is mainly for dev and dr purposes at this time. We are using the 5596'...

Dear All,In one of our newly purchased Cisco Routers, I am getting the below error message : esw_mrvl_vlan_port_remove : Unable to find entry for VLAN(1) dbnum(1) esw_mrvl_vlan_port_remove : Unable to find entry for VLAN(1) dbnum(1)000083: .Aug 21 1...

Hi All,I have a C3825, and have been using standard ACLs and a PBR to route certain HTTP traffic via an alternative default gateway:route-map RTRMAP-OfficeLAN permit 10 match ip address RTRMAP-OfficeLAN-toADSL set ip next-hop x.x.x.xThis is working a...

Hi Guru'sI was wondering what everyone considers to be best practice for network cab cable colour coding?Our network is very fluid and gets patched and repatched as the offices get moved around, this can happen 4 or 5 times a year, I currently use di...

i have the following VTP Domain scenario, and i want to configure VTP Prunning for clearing some Vlans . This configuration is in the 2 Clients.Can configure Prunning in this 2 client???/or i need to make this configuration in the VTP Server????----...

This past networkers I was at the Cisco booth discussing how the 2248 can connect to the 5548 and have server connectivity.  It was told to me that now, as of a fairly recent NX-OS release, you can have the 2248 going dual-homed to both 5548 via VPC ...

                   HI , can anyone tell how many Gigabit port will be supported by Cisco 7206VXR with G1 engine model. By deault we hot 3 GE, is it possible to add additional Gigabit ports with the existing hardware. Please clarify.

Hello,We have a customer with lots of remote sites which have 3750 switch stacks (NOT clusters) in them.We need to discover all the stack serial no's as a requirement for Cisco Shared Support.Campus recognise the stack master.CM gives it the device t...

We recently upgraded our bandwidth and I have to change the ip address on our ASA 5510. I just want to make sure that I am doing it right. All I will need to do is open up the ASDM and under confiugration go to interfaces and make the needed changes ...

Hi!I have a cisco 2610 router connected to satellite modem (CDM-600). Cisco has NM-2W module with WIC-2T card, one port of this card is connected to modem via CAB-SS-530MT=, chassis WIC slot is filled with 2MFT-E1. Everything works fine for several h...

I just wanted to get some advice on designing an IPv6 network in one physical office building, but this office is used by multiple organizations, think of it as a ready to go office space that startup's can use.Whats a good practice to give each orga...