Hi! I want to know how much input/output queue sizes(in pkts or bytes) cisco switches(e.g., catalyst 2970G) have. I searched whole the internet but the one thing I found was the size DRAM of the switches. Furthermore, 'show interfaces' command is sup...
Hello EverybodyI have a Catalyst 2950ST-8-LRE with CPE 575 in use. With the default autonegotiation setting on the CPE port everything works fine but when I want to stet the CPE port speed and duplex, the LRE link doesn't come up after a link failure...
I would like to connect two 4510r (50 Km separated) via FO but it doesn´t seem to support ZX FSPs and the supervisors don´t have GBIC slots. Any recommendations?
Would you recommend having a 1721 act as a DHCP server for one part of the network several switches back or use a DHCP server in that isolated network?
Hello,I was curious as to how granular I can be with bandwidth management on a C2950 switch. What I would like is to be able to restrict any SESSION to 300 kilobits or less depending on the IP Traffic type. Basically what I have is MS Terminal Server...
Okay, I know this is not strictly a Cisco question as the switches in question are HP ProCurve 2524's, but hopefully I'll be granted a pardon for that. I'm trying to create a network with two VLANs who don't speak to each other but can each access t...
How would you configure mac-address sticky on the port for the voice vlan and access vlan to limit to 1 mac address per vlan? Also, is there gotchas running dot1x on the port?Basically we want to connect Pc to 7940 to Catalyst 3560, when one or the o...
Hi there,I have a cluster of 4 2950 switches.lets call them switch1-switch4.Suppose i have a server with ip address 10.0.0.1 hanging on switch 4. Switch 1 is my command switch.I want to set up Access-List to only allow access to this server 10.0.0.1 ...
I would like to be able to use a port of the network module like a port on the router itself. Specifically, I need to : use the port as a real router port (issue something like "interface fastethernet0/5 no switchport") subneting the interface to acc...
Is there a way to put a ACL on a catos box , specifically a 6500 with a sup2-2ge and a pfc2 card ,code version 7.4.3 ? Have looked around CCO and cannot find a definitive doc on how to do this ? Found it for many other switches but not the cato...
If i have a subnet of say 192.168.1.0255.255.255.252, am I correct in saying you cant use 192.168.1.4 , 192.168.1.8 and so on as these will be the networks ?thanks
I have several catalyst 3500 XL (3512) switches that are going down and ports 3, 7, and 11 light up amber. I try to console in with a laptop and can't get a response. Any suggestions on how to fix this?
Hi,Recently i'm upgrading our cisco switches. Among them are some 2940 switches. Cisco lists as requirements:C2940 IOS IMAGE AND WEB BASED DEVICE MANAGER c2940-i6q4l2-tar.121-22.EA7.tar Published 02/Feb/2006 C2940 IOS IMAGE AND WEB BASED DEVICE MAN...
