Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Just wondering if routing protocol control traffic (hellos/updates/etc) is queued preferentially to normal traffic, on a serial link? Assuming *no* QoS/MQC is configured on either end of the link? Also, are pings treated with lesser priority than nor...

Hi, Am having troubles trying to configure our ASA 5510 which we would like to host our servers within DMZ. Packet-tracer doesn't fail and indicates flow is correct. Details about ASA 5510; Cisco Adaptive Security Appliance Software Version 9.1(7) ...

geoff by Level 1
  • 5765 Views
  • 12 replies
  • 0 Helpful votes

Hi Expert, I need support on how to design QoS for the the attached Campus Design. I know that marking and classification should be done as close to the source as possible in ingress direction. policing, queuing should be done on the egress direction...

Hi, I'm trying to remove existing forwarded IP. I'm unsure on how to do it.  I tried "no ip nat inside source static 192.168.x.x 210.x.a.b extendable" Got the "% Invalid input detected at '^' marker." shown at "i" on letter ip. Thanks in advance!

Ridhwan by Level 1
  • 3823 Views
  • 2 replies
  • 0 Helpful votes

Hi, I'm trying to remove existing forwarded IP. I'm unsure on how to do it.  I tried "no ip nat inside source static 192.168.x.x 210.x.a.b extendable" Got the "% Invalid input detected at '^' marker." shown at "i" on letter ip. Thanks in advance!

Ridhwan by Level 1
  • 318 Views
  • 0 replies
  • 0 Helpful votes

Resolved! 1921

Hey, I have ordered 1921 t1 bundle routers, do I need T1 module for this if I want to use it for T1 circuit? it's just confusing because the name of router says " T1 Bundle ". Thanks,

Hello ... Hopefully a quick simple question. Migrated from a Juniper SSG5 to Cisco RV325 and need guidance on Port Mapping. Incoming communication from a web-client comes in on TCP port 80 (IIS) and port 26000 (accesses a DLL). Need to port map the e...

Office A's isp was taken over by another isp, since then we see  ~10-20% packet loss with select internet hosts and many of our other 70 offices on Cisco equipment on different isp's across the country.  Jerkiness and stuttering in ssh to the wan int...

wayfaring by Level 1
  • 2114 Views
  • 4 replies
  • 0 Helpful votes

Hi All, I am facing a strange issues forming adjacency between Cisco 3850 and a fortigate. There are two redundant p2p link. On one link every thing is working fine but one a second link the adjacency is flapping.I am posting here a log which continu...

Trying to choose between 867VAE-K9 and 887va for VDSL2+ and a 2nd WAN (cable) for redundancy backup.Any thoughts?Do they support HTTP proxy (upstream proxy)?Would they balance 2 WANs or can do redundancy (one at a time - with auto fail-over) only?Wha...

it by Level 1
  • 9903 Views
  • 13 replies
  • 0 Helpful votes

We have a handful of small business customers where we put Cisco RV042G Dual Gigabit WAN VPN routers.  A few months ago, while checking on some port forwarding for one customer's phone system, I was not able to get to the router web UI via the IP aft...