Routing

Hi experts,Here is the config on my router and I am trying to understand the drops for cs6policy-map llq-policy class voice-all-out    priority 3000    police 3000000 conform-action transmit  exceed-action drop class class-default    bandwidth remain...

I would like to share the knowledge I gianed to get the ASR 1K Box to box HA with ZBFW working in a WAN to LAN topology.  We worked with Cisco (from TAC to DE's) as we were one of the first rolling this out.  In the process we defined an alerternativ...

Hi ,Please let me know the concept of L3 point to point link between Router and L3 Switch.Thank you

Hi allI have 3 routers where I want to load balance traffic between them, these are between site A and BThey all connect to a core switch on both ends.I want each router to be a failover of the other, what is the best method of achieving this ? I wan...

Dear,I have an 'strange' question .We have an router with a lot of connected routes (PPPoE Sessions) Too many of this connected routes, we have static routes in place as well.I want to have a backup router which takes over all traffic when one fails....

HiI am seeing following non-stop IPC-watermark log messages suddenfully from one of our 6500 switch.IoS version : 15.1 SY(1)Apr 12 10:00:11.593: %IPC-DFC1-5-WATERMARK: 17238 messages pending in rcv for the port Card1/0:Request(2010000.6) seat 2010000...

Hi everybodyThis is a 3750X with ip services.I spend already some time researching and still nothing.This is my issue:I have this route that exists in the routing table learned via BGP but is not redistributed into OSPF!!!VAN-DMZ-SW#show ip route vrf...

Hi All,Trying to connect 2 switches together (both 2960G 8 ports). I have an SFP in each (GLC-LH-SM). They are connecting over SingleMode Fibre using the correct cabling. The fibre cores have been tested and are all ok also.I can't get no Layer 1 con...

can i do this similiar to spanning tree?  i know i have to have 2 HSRP capabale devices. only reason i ask is because i had an issue yesterday morning where i had to take down our L3 switch with all of our routes.  i want to slowly convert my network...

HiI've got a PBR configured in a interface Tunnel (with NHRP) that's not matching all the traffic coming from spokes...Trafic comes from networks 10.0.0.0/16 10.1.0.0/16 10.2.0.0/16. Enters the tunnel, enters a VRF and with the PBR we split those net...

I need to change an ip address and route in remote, because this is the only access to the router I will loose connectivity.I thought it was possible to put a file in flash and configure it from there, how should it be done, is there somewhere an exp...