Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

“Webinar

 
Labels

Forum Posts

Start a conversation

Resolved! not exceed threshold values for Cisco switch

Hello, Sir/Madamfinally, I've just found a web page that there are some documents, which is contained the recommended threshold values.but there is just only very simple sentense."below values' source are from "Cisco DCN"Those documents are called " ...

wan technology

hi! we've vpn tunnelling (through internet) and mpls in my environment? I would like to find out that will increasing the bandwidth of the internet line for vpn tunnelling improve the performance? We've a few small branches of about 30 users each tha...

QOS - Policing example

Hi, thanks in advance for any help you could give me.I'm trying to configure QoS between my US site and my UK site.  Here are the details:1. Leased line has a bandwidth of 3Mbps.2. I have 5 queues: Voice (ef), Control protocols (af41), Video (af31), ...

vincehgov by • Level 1
  • 664 Views
  • 2 replies
  • 0 Helpful votes

Internet backup link

My goal is to provide an Internet backup (failover) for remote sites and headquarters.Each site has its own Internet connection via pix/asa firewalls. The attached topology is a footprint of remote sites connection to HQ.All internal traffic through ...

Resolved! How to change LAN defautl gateway (ISP) automatically to another gateway when goes down?

Hi:I was just wondering, if its possible this scenario. I got a client that has two buldings; each of this buildings are going to have one blades systems for virtualization of the servers, synchronizing constantly using a software that makes this. Ea...

Multilink drops

We have a 2821 router with a two port T1 card, and two T1's.  They are in a multilink which as fragmenting disabled and is doing netflow.  The serial links are configured for fair queueing, and are not experiencing any drops or errors.  Any thoughts ...

Basic access rule problem

I have a private network located on a corporate network using a Cisco 851 W.  I want to block all access to the coporate LAN from behind this firewall which will be used as an access point to provide internet access/  I have done this sucesfully with...

Resolved! Extranet MPLS VPN basic question

Hi,Imagine CompanyA acquired CompanyB. Same ISP for both companies.Now CompanyA wants to access network from CompanyB (one-way access).For this MPLS VPN Extranet scenario, do you know any good document explaining which parameters service provider is ...

news2010a by • Level 3
  • 805 Views
  • 1 replies
  • 0 Helpful votes

GRE over ipsec with EIGRP routing

hey guys please can you help me on this issue, I have a hub and spoke topology regarding to gre tunnels and the routers are running eigrp across the wan, the question is I want to redirect all the traffic across the tunnels first just let me tell you...

Resolved! OSPF Failover.

Hi,Have the following setup:CE with 3 LAN Subs:ip address 10.1.1.0 255.255.255.0ip address 10.254.1.0 255.255.255.0ip address 192.168.1.0 255.255.255.0And 2 Eth WAN(A+B) connections both running ospf.We require both WAN links to advertise all 3 LAN s...

No ACL matches on deny statement.

I'm using a 3845 with an internet facing ACL.I have all my permit statements in the ACL which are working correctly and I can see matches on them when I do a "show access-lists".However, the last line of my ACL is  "deny   ip any any log" but no matc...

View All
Review Cisco Networking for a $25 gift card