Hi I am trying to figure out how access-list work from a bgb environment using cisco 2821 flash:c2800nm-advipservicesk9-mz.124-7a.binIs it ingress or egress from the Ethernet or serial interface that access-list 6 is applied? router bgp 200 no sy...
I have a Cisco 2811 that is connected to our Service Provider over an MPLS network running OSPF. We currently have (2) T1 cirucits and we are load balancing the two. I am going to add a third T1 but was told I need to do MLPPP.First, will this router...
Router A 3600 --- Router B 7200Can telnet from Router A to router B but cannot do vice-versa.When I try to telnet from Router B to router A we see Line protocol going down and coming up and doesnt connect.no access-listsput transport input all under ...
I'm trying to recall the memory utilization inherent with filtering BGP prefixes.I seem to recall somewhere that if I have a session between router A and router B, where router A sends 10 routes to router B and router B has a filter to accept only on...
Please help me on this?.I need to forward traffic to two different next hops based on source IP and the attribute (tag, community, other your suggestion) the BGP passes with the route that points that source IP.I?ll try with an example: I have two di...
i would do to web publish from the isa backend so the sceenario would be something like thisHow would i configure the cisco router?internet||fe0/1(x.x.x.x what would this be public ip?)cisco 1841 with k9 security set|fe0/1 (x.x.x.x what ip would this...
Thank you all for your information ...i have this network topology and configured using RIP v1 in my virtual lab ...192.168.1.32/27---R1----10.1.1.0/24-----R2------192.168.1.64/27by default it shouldn't work using RIP v1 but it works well..we have di...
Hi , I have congfired a access-list on my Internet router 3845 as attached to block ports 1720 & 5060 , but when i apply it on the intended interface the BGP state goes down.Is my configuration correct ? Also suggest .
hi... is true the qos on mpls is by learning TE? i wonder why there is tunnel interface. would you please teach me. i dont have much time to learn at the thick book. i am proud to implement this if it benefits or just works at my medium size organiza...
Hi everyone! 1st of all i'm interested in support of Distributed Traffic Shaping on NPE-G1 (fixed interfaces), 10nx in advance. The problem is: i create a policy map with classes within, make shape average and i can see Traffic Shaping values for amo...
Hi,I have 4 etherdrops from a single ISP but at different POPs i.e. 2 links from each POP. I have static routes for my subnet pointing to router of POP1, & same router wit higher AD at POP2. Now, problem is when my POP1 goes down traffic doesnt come ...
Hi allclassic problem where looks right, but no adjacency is established.I checked MTU, authentication, I can ping remote interface.R1interface TenGigabitEthernet2/3.304 encapsulation dot1Q 304 ip address x.x.x.x 255.255.255.254 ip pim sparse-dense-m...
We have a lan with subnet as 10.101.0.0/23 - i.e 10.101.0.1 - 10.101.1.254 usable host ip are available.Lan is connected to firewall and to our WAN networkNow that lan users are increasing everyday and we may run out of IP address.Solution to the abo...
