Routing

I have some routers to be configured for TACACS+ management authorization. What will be the source IP address of the Tacacs requests?- Will it use the loopback address?- or the ip address of one of the route interfaces?- can this be configured?

Hi All,Does IGRP/EIGRP supports equal cost path load-balancing by default upto 4 paths ??? I think We use Variance keyword just to configure the protocols for unequal cost path load balancing. By default what's the behaviour ???Eigrp can loadbalance ...

Hi All,Can we have the primary and secondary IP address of the router interface on the same subnet. Like interface FastEthernet0/0 ip address 192.168.1.2 255.255.255.0 secondary ip address 192.168.1.251 255.255.255.0router#ping 192.168.1.2Type escape...

Hi, I have two VPN links which I wish to do "per connection" load balancing? Is this even possible?If so, how can it be done?______________________VPN link 1 _____|SW -----------LINUX box--------|_____________________VPN link 2 ______Would appreciat...

Hi All, Lan A|Router A|--Internet--|Router B|Lan B Above is my network Diagram, and ip addressing for the dia is as, Note that this is DSL connection i am getting the Wan ip address from ISP. Router A Ethernet : 200.200.1.0/29 Router B Ethernet : 200...

Hi allOk i have killed my 837, it booted up into rmon and i tried to reset it to factory default, all it does now when i hypertrm to it is display 'br' and thats it.

I have put compression on one serial interface of 2600 router,netflow does not monitor that interface.is there any way so that it will be to monitor it.Netflow shows statistics of all other interface . when ever we use this command 'show ip cache fl...

Hi All,We hv a internet router with internet leased line connectivity.I want to put access list for filtering unwanted traffic.I will put access-list in inbound direction on the fastethernet interface of the router and in the outbound direction on th...

Hi,I try to search for minimum requirement for bootimage to bootup IOS from ATA Flash Disk which runs on RSP4/4+ but did not find any?Thanks.

I have a WS-C2912MF-Xl switch with two 2601 routers connected connected via FA1/1 and FA1/2. on theswitch FA1/1 and FA1/2 say up and upon the both routers FA0/0 is up and down, is therea switch configuration I need to set up to get the routers to tal...

dears, i want to add keepalive in the tunnel interface i created in 3620 router but i ddidn't find keeplive command present pls. what is the IOS release/images that support keeplive command in thr tunnel interface. ...

Hi,We have Cisco 2611 XM (12.2(8)T10) acting as backup ISDN Router. The remote site routers dial-in to this router when the Serial Link fails at those sites. We have the "dialer idle-timeout" parameter set to 180 at both ends.However during an Active...

Problem Details: I am trying to do per-packet load sharing across two DS3 circuits to achieve 88Mb aggregate.Attempting to use per-packet load sharing on the DS3 interfaces results in dangerously high cpu utilization.CEF load sharing appear...

Hellowhich is the function of this command? I'm looking in the command reference but it doesn't appears.interface ATM0no ip addressno ip route-cacheno atm address-registrationno atm ilmi-enablebundle-enabledsl operating-mode autohold-queue 208