Hi All, If an OSPF router has two default routes sent to it, via different routers and they are both E1 type routes, does it base its route selection on metric only? My reason for asking is, I have a router is running two OSPF processes and receives ...
How do you set up a layer 3 vlan on a 5020. It seems to be different than say a 4948. I jsut want to do something like:int vlan 10ip address 1.1.1.1 255.255.255.0
Hi,Over the last couple of months we have experienced about 5 Ethernet card failures, with another three happening late last year. The problem results in all Cisco IP phones on the card losing power (the phones are powered over Ethernet) and the PCs ...
Hi,I was trying to segment my internal server networks with Cisco ASA 5580-40 FW. The different servers were segmented into different vlans and works fine without the FW. However, whenever the FW DMZs are connected to ports associated to the differe...
Hi Would you please let me know is there any way to change the HTTP header value (X-Forwarded-Proto) using the CSS 11500 series switch?I tried searching in google and cisco couldn't find any links related to this.Would be much helpful if someone can ...
Hi all These is a silly question but pls give the information about ip virtual-reassembly and encapsulation ppp ,why we use that and if not use what happened ? pls...
Hello, I have a L2 scenerio on cisco switches 4507 like.RAS Router-->Cisco 4507 Switch A(Trunk Port)--->Cisco 4507 Switch A(trunk port) with another 4507 switch B---> Access Port on 4507 Switch B (from where one IP DSLAM connected). Problem is tha...
Hii have cisco 2851 wan router connected to 2 differnt cisco 3560 switches.The 2 on board Gig interfaces are part of BVI interface and ip has been given to BVI interface.Both cisco 3560 swicthes connected to each other on fa0/24.Gi 0/1 of both switch...
okay,call me stupid, I'm fine with that. My xbox 360 has recently informed me that in order to connect to xbox live my router, needs to be running a minimum MTU setting of 1364,unfortunately for me, its a friends router and i cant seem to find out th...
Dear All,I am trying to install 2 additional HWICs ( 2*FE) in a 2811 router but it is not detecting these interfaces. I am getting following message in logs,"GT96K_FEWAN-1-UNKNOWN_WIC: NM slot 0, wic card has an unknown id 53A"What could be the possi...
Hi,We have two 10GB links using the Cisco 10GB LR x2 gbics in a 8 port 10GE card (WS-X6708-10GE), one which is showing high optical loss, while the other is fine. gw-01#show int transceiverTransceiver monitoring is disabled for all interfaces.If dev...
We currently have a Cisco 2821 which does not keep it's changed configuration.For example, after adding the MOTD, saving the config (#write memory and #copy run start) and reloading the router the changes are losted. Has anyone ever run into this pro...
Hi;We've got two 6500 series switches with WS-X6066-SLB-S-K9 module.We want to implement load-balancing mechanism between modules on switches.Which method have to be used ? HSRP or GLBP ?Thanks.
I'm traying to setup two simple vlans on the cisco 3548 XL. They both will connect to a cisco 2600. At this moment, I have been succesful creating the two vlans in the cisco 3548 xl and created two entries on the cisco 2600 fa0/0.1 and fa0/0.2. Howev...
