Switching

Hello, I would like authorize the access in the internet since a cisco router 1760 with according to hours and according to the mac address customers host. Be this possible? If yes how I do have to make?Thanks...

Hi,We have a C6500E with WS-X6704-10GE cards and XENPAK-10GB-LR+ modules.This coreswitch is connected to an EMC Solera SAN, via a catalyst 3750E switch.On the other end, the 6500 is connected to HP bladecenters via CBS3125X-S bladeswitches.For iSCS...

i'm doing some old-school stuff here but for the life of me I'm not getting the routing correct.i have a remote office RTR (1700 rtr) connected to the central office RTR (2851 rtr) via their fastethernet ports.to setup a dial up back up solution i pl...

Hello All, I have a cisco VTP domain setup, incase I decide to add another vendor switch(say nexus/juniper), how can I get them to speak to my core switch as these switches dont support VTP. Manually creating vlan and using dot1q tagging/trunk...

Hi allCan I use loop and root guard with RSTP ?and what is the best practice config for these ?

Hi..I would like to know that How many number next-hop support when I set the PBR at C6509?When I set the ip next-hop in pararel , Is it possible loadbalancing per each next-hop?at conclusion. if you know that, please let me know the link thank in ad...

Hi I have a few 2960G switches connected into a ring topology with 3750E (EMI) stack. The 2960G switches are configured with 2 vlans. There are some multicast sources that must be connected to 2960G switches and the hosts receiving multicast traffic ...

Hi,I know it's important to set "enable secret password" but I can't understand what's the importance to put password's for line vty?Hope you can help me understand guys. Thanks.

If I have a PBR and use the set ip next hop, what will happen if the next hop disappears? Will the PBR in a way not function and fall back to the gateway of last resort?

Hifrom configuration guide we can set speed no negociate on C3020's SFP portbut i do no find this command see aboveany comments welcomedJYPCisco IOS Software, CBS30X0 Software (CBS30X0-IPBASE-M), Version 12.2(50)SE, RELEASE SOFTWARE (fc1)Copyright (c...

Hi;On cisco 6500, we use ip named acl lists with header numbers like 1,2,5,100,200 etc.But when we restart the switch all this acl numbers become 10,20,30,40 etc.Is ıt normal ? if not what must we do to protect these numbers ?Thanks.

We've been setting privilege levels on the vty lines, like this:line vty 0 4 privilege level 15 login authentication [Radius] transport input sshBut then we started playing around with our Radius configuration to see if Radius would convey the privil...

I am needing to configure two 3750s with HSRP so that I can get a virtual IP address. 3750 #1 will have one of my internet connections and 3750 #2 will have the other. Can I use IP SLA so that if Internet connection on 3750 #1 goes down that the de...