Switching

Hi allPlease tell me how many Etherchannel can I create in a 2960 Switch?ThanksSudeesh

Hi there,Our network currently does not have redundancy and we are in the process of putting redundancy in place. I've done a bit of reading and I came up with the attached drawing. We currently have one of each and will be purchasing an additional...

Hello, I have an issue here and i need your help.A cisco 2821 router hangs after some period of activity.When i started the router it boots normaly and just before the enable to mode the router hangs and does not respond to input.When I change the co...

I am attempting to remove a WS-X6408A-GBIC 8 port 1000mb GBIC Enhanced QoS Rev. 1.1From our CAT6509. It is running the Supervisor 720 w/ PFC3bxlIOS Version 12.2(18)SXF9When I do, I receive no errors from the cat 6509, but the edge switches plugged i...

Anybody know where you can find firmware upgrades for the modules in the Cat6500 (WS-X6148-RJ21V)? I have found some upgrade software for the service modules but not for any others. Any suggestions or maybe a good document? Thanks

Can I mix TRANSCEIVER of diffrent types to connect devices. i.e. Can I connectiona Cat 3560 SFP transciever to a GBIC transciver on a cat 4506 line card?

I have a 4510R-E switch operating as Core. I have 3 4507R-E & 2 4506 switches operating as access switches. the 4507R-E switches are new switches which is recently got to network.the core switch is in server mode & the remaining switches are in clien...

Hi all, Does the 2960G support ip routing? Thanks.

I can't get port authentication to work. ACS 3.0 using Radius Cat 3560's Windows EAP Type = MD5 Challenge I get prompted to enter my password and it fails authentication. I am thinking something is mis-configured on the ACS 3.0. I am only trying it t...

When using bgp prefix lists to filter routes is there any way to do a "permit any" like in a ACL or is this a restriction using prefix lists ?

Hello, I have a 4507 Cisco Switch and I have 10 Gigabits port on the supervisor module. I want to convert thoses 10 gigabits port to a 1 Go port for RJ45 connection.Do you know if it's possible and if you have the right model number.Thanks.

Having hard time to remove community string in cat OS. Document says clear snmp community will do it but i don't think it is the case my config is as follows set snmp community read-only mycommunity1 set snmp community read-write mycommunity2 set snm...

What is the difference between broad storm control and unicast storm control?How it will work seperatly?