Switching

Dear All,If have IP-address only and I want to know in which port that particular device connected.Regards,Naidu.

Can any one suggest why these logs are gettting generated .1805695: Feb 4 01:52:53.919 IST: %C4K_PKTPROCESSING-4-UNKNOWNBRIDGEORROUTE: Unable to determine whether to route or bridge replicated software-processed packet with source address 00:0F:20:9...

Can someone please tell me what the command is to get back to the router#?It's currently at the boot# please reply to josejimenez5@comcast.netThank you!

Given the output from "show ip route 10.1.0.0" command; what is being done to the specified minimum bandwidth to arrive at the metric? I know the formula comes down to 256(bw+delay) but bw is in Kbps and ends up being divided into either 10E6 or 10^...

What's the command to switch between the active and standby supervisor cards on a 4500 series switch?

Dear Netpro!this command enough to come up the 802.1x:aaa new-model aaa authentication dot1x default group radius ordo i need the seconde Line:aaa authentication login LOCAL line enable local none then://line con 0 login authentication LOCAL//line ...

I am having a problem with a 4507R. I have 2 SUP II+ modules installed in it and the SUP that should be the standby is not booting all the way. If I have one SUP inserted, either one, it boots fine but when both are inserted one becomes active and ...

Hi,I want to purchase E1 module that are supported with plateformCisco 7206VXR (NPE-G2)I have found a module PA-MCX-2TE1 and one isPA-VXC-2TE1+ =2 port TE1 hi-capacity enhanced voice PA Kindly tell me which module is best.I am confuse abo...

HII Have to Know the Following:where/when we should take in place/Design the Following Commands in Pim Mode1)sparse-mode2)Dense-mode3)sparse-dense mode4)where/When we should use ip pim send-rp-announce Loopback0.....5)where/When we should use ip pim ...

we are trying to monitor what our network engineers enter as commands when configuring cisco devices. so we think the best solution is to use accounting feature.when configuring aaa (accounting):router(config)#aaa accounting commands ? <0-15> Enabl...

1. Given an L3 GEC comprised of four GigE ports that interconnects a distribution-layer router and an access-layer router, if I have netflow enabled on the distribution end of the GEC, is there any reason/benefit that I should enable netflow on the f...

Hi Gurus,I have a T1 FR circuit between my core router and a remote router. Do I need to configure "network-clock-participation wic 1" global configuration command for proper functioning of FR-T1 circuit? Moreover, what is the differance among the ef...

Hello,i have the following problem and i don't know what is it related to.From time to time (usualy once in 10 minutes) all leds on all access ports changes color to amber for about 5 seconds and then back to green.Users on my network don't report ne...

HI TO ALL I HAVE CATALYST 2950 AND LINKSYS SRW2048, I AM ABLE TO GET THE CISCO SWITCHES THROUGH TELNET FROM THE CONTROL ROOM IN WHICH WE HAVE LAYER 3 CHASIS SWITCH , BUT I AM UNABLE TO GET THE LINKSYS SWITCH