Switching

Hi folks,just a question: with two 6704 4x10Ge modules could I create a 20 Gbit EtherChannel with two links on different modules?I've tried, but one remains always in err-disable, and I don't understand why.Any advice will be appreciatedRegardsAndrea

Hi,I notice that the "Received ### Broadcast" in my 2960 L2 and 3750 L3 switches is accumulating even though no data is sent, worse if there are data sent to the ports. I don't see this in 6500. What could be the cause of this and can it be eliminate...

hi, i have a 2960 switch, on whic i have to limit the bandwith on port fa0/25 to 100kb/s. i tried the command "srr-queue bandwith limit 10" and defined "bandw 1000" on the fa0/24. so 10% of 1000kb/s is 100kb/s - but there was no effekt any idea ?

Hi - I have got 2 3560s runnning 12.2(25)SEB4 connected to each other over 2 Gig TX links in a channel. Config of each is below;Switch 01!interface GigabitEthernet0/47 description *** Etherchannel to Switch 02 *** channel-group 1 mode auto!interface ...

Hi all,my 857W doesn't like me. I can do whatever I want it will not accept the LAN IP I have entered in the SDM setup. It says its preparing coammnds for delivery and after ~2 minutes it loses connection to the router. But when I restart the SDM and...

Hi:Please check the figure 27-1 in: http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12235se/scg/swudld.htm, regarding UDLD operation:1) In the failure event, why Switch "A" doesn?t disable its port based only in Layer 1 mechanisms include...

Hi,im wondering if in the following output:?????#show vtp statusVTP Version : 2Configuration Revision : 10Maximum VLANs supported locally : 254Number of existing VLANs : 11VTP Operating Mode : ServerVT...

Is there a method to find out the packing content of shipping box? For example “Catalyst 3750-E Switch Getting Started Guide” claim the AC power cable is enclosed, but there is no information about TwinGig Converter Module. Cisco Dynamic Configuratio...

GreetingsI have a CSM load balancing 20 apache servers configured as layer 2 servers. The probe in question is configured as shown below. probe HTTP_WS tcp interval 20 retries 0 failed 30 open 2 port 80When we restart apache and the web applicat...

Hi,Can I connect a Cat2970 which has 100 FX module to Cat4503 which has a 1000SX module?Will it work?Thanks and Regards,S.Venkataraman.

Hello.I'm trying to set up some thin clients to boot from a TFTP server. DHCP is controlled on our network by a 3825 router. As I understand it (I've never set up thin clients before) in order for the terminals to boot from the TFTP server they need ...

Hi all,We have a 1721 box configured with a Vlan, two ports added to this Vlan. I wonder how to know what mac address is linked to fas1 and what mac address is linked to fas2. I have been trying lots of commands getting just informacion about the vla...

Hi,actually i have never used vlan 1 and interface vlan 1 L3 interface.Recently i noticed a spanning-tree loop in my network. Although it worked before with no no spanning-tree vlan 1 disabled, now it caused the loop.Vlan1 was enabled automatically o...