Looking to repurpose the 4000w Power Supply into Amateur Radio Service by upping the 42vdc output into the 55vdc+ range. Total power draw would remain below 4000w. Other voltage outputs can remain the same. From the looks of the circuits inside the p...
Hi,Following is the requirement Guest Wi-Fi for external users: 1. User must be authenticated with MFA. User can be pre-defined with email/mobile.2. Authentication must NOT be on AD or ISE.3. External captive portal can be used. Separate auth server ...
Hello,I have mistakenly installed CAPWAP image on the WP-WIFI6 WIM module on my IR1821. I am now unable to install the UIW image that contains the WGB capabilities. The archive download-sw loads the image, but refuses to accept it. It prints the foll...
Hello, does anyone have any advice on how to resolve this issue? The problem is the first time a user signs into a workstation they do not yet have their certificate from our CA which does provide a user cert automatically, but not before the Windows...
9800-40/80 17.15.4 running local MDNS gateway drops all MDNS advertisements, services are being learned and cached correctly from wired sources but advertisements are always being dropped before they go out to clients. Can observe this happening in m...
I was trying to use the sandbox but it requires cisco secure client. When I try to download cisco secure client it requires active contract. So is this not available for personal use?
Hi, please can someone explain if we can have FPR 1140 with FTD to be context to migrated asa 5516 with firepower context.basicall we have asa 5516 contextual with firepower module now we have to move to new hardware we notice cisco built new hardwar...
Hello to all out there,I understand that when pushing changes to a cEdge device using vManage, there’s a rollback timer feature. This allows the device to automatically revert to the previous configuration if it loses connectivity to vManage after a ...
I have built a fabric using NDFC with BGWs, how do I extend my L2 VNIs in the fabric to an external network? Can I connect my core in the external network via L3 to the BGW, and configure an overlay network to extend the L2VNI? Does NDFC have automat...
Hello, can someone please help me configure these 2 ? I connect the router on the 0 int and at the 1 my pc.I want dhcp.Please help me.The commands are different from the 5510 and 5520 i had.
Hello, I have two routers 1121X and 4221, and when i tried the penetration testing, i got the result below:# algorithm recommendations (for Cisco IOS/PIX sshd 1.25)(rec) -diffie-hellman-group-exchange-shal kex algorithm to remove(rec) -diffie-hell...
Hi! We have enabled second 5GHz radio on C9136. Mode client serving. No FRA. We observe that clients connect to second radio, which is good. I'm want to understand... why? Let me elaborate.From previous tests, we found (3800's, 9130's) that no client...
