TelePresence and Video Infrastructure

Hello!Can someone please give a brief explanation of how this Cisco TelePresence Multipoint Switch works (not the switching functionality).http://www.cisco.com/en/US/products/ps7315/products_licensing_information_listing.htmlNeed information on setti...

Is there a way to call from a registered system on a VCSC/VCSE to outside polycom using an ISDN/phone number?

The latest versions of E20 and C-series software support "Vlan mode: Auto" which is great when using voice/data vlans in conjunction with CDP.TMS 13.1.2 allows you to set Vlan voice mode to auto on E20s using templates but I can't see the same option...

In the productsheets of the C-series I see:Firewall Traversal: - Cisco TelePresence Expressway technology- H.460.18 H.460.19 Firewall TraversalDoes this means these endpoints can do traversal directly with a VCS-Expressway without needing a VCS-Contr...

Hi,We are trying to integrate Tandberg Codian MCU 4505 with Microsoft Lync server 2010.We do not have any VCS in the setup.If anybody has tried it before, please suggest configuration to be done on Tandberg Codian MCU 4505 and Lync server.Regards,RN

Hey all,How can I get TMS to send me an email when a VCS submits a 'Resource Limit' ticket to TMS?  I see the 'System Resource' event under Event Notification Levels, but when I go to Event Notification Manager I cannot choose this as an event type t...

need help on upgrading the Tandberg 6000 mxp from codex 3.1 to at least 6.3.please help.Thanks Jody.

I have looked into some of the EX90 documentation but I do not see references to the use or planned use for the USB ports that are on the back of the unit.Can anyone shead some light on this or am I just not looking in the right places.Thanks.

Hi Everyone,Hi have a TMS in a DMZ and a coupple of C20 in LAN;I have open from DMZ to C20 the following port : 80,443 TCP and 161 UDP. But TMS can't reach the C20.what are the correct ports to open in the firewall for add the C20 in the TMS?thansk,C...

I'm looking for a doc that covers setting up the 8710 blade in and MSE8000. The Cisco TelePresence Server MSE 8710 Getting started doc seems to only cover the installation of the blade into the chassis, but not how to configure the blade to allow CTS...

Good morning everyone,I have a problem with the cisco Endpoint EX90 . If the endpoint is registered under Radvision ECS gatekeeper, after 1 minute of inactivity, not respond more to any call. To redo work I have to make a call from the EX90 to anothe...

Hi,One of our Client are planning to establish a SIP trunk with thier customer for B2B Video communication.The trunk should be established  between Client's  VCSC and thier Customer’s Session Border Controller.Kindly let us know the hardware compatib...