I have the Cisco IPVC-3545 version 5.5, and when I start a videoconference I see and hear a welcome message which is in English. I can change the language of this message ?
i am working on cisco AS5350 we have install pgw200 which is connected to Seimens EWSD switch via ss7 AS5350 has SLT functinality we lost pgw200 password & need to configure few gatways with this pgw2200. need to know any one can help me this regard...
I want to establish videoconferences using a cisco 7985 against an external system. At first I thought that I had problems with numbers that belonged to video peers, but then I realized that it was the same with normal peers, but always that I used t...
We currently use Sony Video conference units for our end units. On the backend, we use a Cisco 3515 for multipoint conferences.We now need to be able to do video conferences with external parties using our MCU.Since there are many ways of doing this...
I was wondering if anyone has had an issue with using Router on a stick with GRE tunnels, when sending IP video (MPEG4)? The router on the stick is needed to make a tunnel across a non-multicast network. Feeds are put into a 3750, which is trunked to...
I have a customer requirement to proxy video calls before sending through their firewall. they currently have a Cisco IOS endpoint gatekeeper 2821 ISR running IOS v12.3. Also less than 10 endpoints on the network. I have read SRNDs & border elemen...
I have cme 4.1 running on a 2851. I have configured some 7921s on the router. When they boot the firmware upgrade fails. Below is the code.tftp-server flash:APPS-1.0.3.SBNtftp-server flash:CP7921G-1.0.3.LOADStftp-server flash:GUI-1.0.3.SBNtftp-ser...
Hi,I have a MCS 7816-H3 installed and need to upgrade to the - Default User Locale - german. But in CCO I dont find the right software. Any ideas where to find it?Thanks in advance
Hi,What happened to 6.0? I have 4.1(2) running with Exchange 2003 and am looking to upgrade. I'm a little confused about the Unity versions. I am about to read the release notes for each version but wanted to find out if anyone has experience with...
We are working on incorporating or upgrading a 3.2 cluster to 4.2. for CCM and Unity. Can we BAT the profiles User/Devices from one to the other. Also what are some of the challenges that we may encounter.
I have a remote site connecting to a secondary site using a GRE tunnel. The remote site has a second GRE tunnel to the main office. The remote site and secondary site are connected to allow VoIP traffic. I am having intermittent bandwidth issues resu...
I have media service server transmit video using ip multicast I have Cisco routers 2800 and 3350 and I am enable PIM dense mode and multicast routing also enable , I am using Cisco switch 2950 and I enable IGMP snooping .in such situation my vid...
Anyone get this to work? My VTA is working and it see's the phone but when I try a call over VPN it doesn't work, no video. The phone and PC are on the same VLAN, the PC is plugged into the phone which is plugged into a poe port on the asa5505. Vi...
I have a CCm 4.1 and a 2841 acting as a gateway. Also have a FXO card and in one of this port I have a direct line. I have configured a connection plar on this port to dial the number 9030 (that is my hunt group) and configured a voip dial-peer point...
