TelePresence and Video Infrastructure

I have a scenario in which one E1 card is installed on a 2600 router and is connected to the alcatel PBX. I need to configure the e1 card for this to work.WAN is terminating on this router and the remote phones wants to access the digital phones afte...

We want to enable vide conferencing between multiple remote sites, however, our providers backbone does not support multicast traffic.The question I have is if I have 2 users in Boston, 2 in NYC and 2 in SF for video conferencing, is the traffic outp...

Dear All, I connect my cisco AS5800 to partner by GW2GW. When partner send me code 17 (user busy) but my AS5800 does not generate busy tone. It generate some sounds like "to te ti".Anyone have this problem before?My IOS software is c5800-p4-mz.123-6...

Hi,I have been reading a few posts and am slightly confused about how I can get 3 way video conferncing with VT Advantage.We are running CCM 4.1(3). With an IP/VC 3510 could we have 3-way video conferncing? Will we only see the loudest speaker in the...

I have just acquired one of these video units so it would interact with my CCM.I have followed all of the details as recommended @ http://ftp.tandberg.net/pub/software/endpoints/cisco_call_manager_series/ with no joy at all.The release of the Unit is...

Is there anyway to AAA callmanager 4.1. does callmanager support AAA ? right now i access callmanager through https and has local username and password. altaf

Is it possible to forward an incoming call from ptsnto another number on pstn?I am using as5350.How do Isetup pots dial peer to achieve this?Thanks.

I have a Cisco 3845 connects to Call Manager 4.1(3) and Norstar via Full T1 CAS. MGCP is working fine, and I am able to call from IP Phone to Nortel Phone and vice versa. Today I noticed that I couldn't use automated features when dialed the toll f...

I'm setting up QOS in a 3560 switch for a video conferencing unit that is plugged into one of the ports. The video unit generates packets with these values:voice packets - dscp 46video packets - dscp 34call control pkts - dscp 24I run 'auto qos voip...

If I just have E&M card in a router, is there a way I can create a local loopback on the router?

Good afternoon, everyone. I am in the Marine Corps, and came here hoping to find an answer to a problem I have with a Cisco 3427 IP/TV content manager. I don't know very much about Cisco's IOS, but I do know that the content manager runs something si...

how can I play video over VPN link ? I have video streaming server at one end and client at the other. Thanks in advance.

Hi All..Can I use ATA 186 or 188 to connect with many others ATA or router with FXS VOIP without gatekeeper ?ThanksCassio Gomes

Do video end points need to register to a gatekeeper for CallManager 4 to resolve e.164 addresses or can CM take the place of the gatekeeper and handle all resolution? Either way, what enhancement is gained by using CM instead of solely using the ga...

I have on my network a gatekeeper based com 2501 that is used by 5 AS5300 remote gateways. This environment is working well.Now I need to redirect some part of VoIP traffic (where I don't have POP) to another network. So, we install another 2500 with...