TelePresence and Video Infrastructure

Hi I want to implement Videoconference using H323. I will use a 7507 with the following System image file "slot0:rsp-jsv-mz.120-7.T.bin"Is that ok or do I have to upgrade it.Regards

I need to configure 4 E/M ports on a voice router for PBX integration. Can somebody share this sample configuration. My aim is to have the analog phones on the PBX side communicate with the IP phones on the IP network thru a callmanager. Thanks Rgds ...

Hello,,How many voice calls can I terminate on Cisco 1760?I think max 16 voice calls with 4 port FXS but I am not sure.What about ISDN PRI???thanx for helps...

The scheduled video presentations will play fine. But if I try the On demand or Videos to playback I get a message at the bottom of the player that says "you are not authorized to access this VOD file Content Manager 10.x.x.x " Any ideas on what i...

Dear Sir/Madam.I have 2 sites connect together by 2 router 2620 + frame-relay 512K. I want configure QoS on routers to uses for Video conferencing (h.323).Can you help me.Thanks & regards,NhuongPham

Hi,We are running VoIPovFR to a remote location, which has 2 x 4FXS/DID module installed into a C2621XM chassis. We are using IOS c2600-is-mz.122-15.Out of the 8 ports, two continually go off-hook, FXSLS_WAIT_OFFHOOK before finally going into a FXSLS...

Is there anyone out there who is successfully running Unicast RTCP with IPTV/StreamWatch version 3.4 or above?Unacast is the default config starting with v3.4 and I have always had to re-enable RTCP Multicast in order for StreamWatch to funciton. Ci...

This question came up at work, does IPTV work on a VPN connection using DSL or cable high speed?

Began setup of 3511 MCU to integrate with Call Manager 4.0. Followed steps in setup guide but along the way something got hosed.Cannot get to reset screen to go back to factory defaults. It gets to an SNMP startup error and just hangs. I receive t...

I am looking into integrating video endpoints (VT advantage SCCP and Polycom H323) in CM 4.1.I was looking in the SRND doc for Video Telephony.can I have my PSTN gateway router (that I use for the callmanager) function as an H.320 gateway for Polycom...

when I try to load the application using the call application command. I get the following error below. The script am loading is is not modified, I just downloaded it for Cisco.Thanks in advance===============================================router26...

H323-gateway voip interface H323-gateway voip bind srcaddr 1.1.1.1these are the two commands for h323-gateway. My question is if "h323-gateway voip interface" has already activated this interface part of H323, obviously this should be the H323 source...

I'm having an issue with Vocera badges and I wanted to see if any of you were going through the same thing. List: 6509s w/720s, WLSMs, and Cisco 1200s (APs) My tunnels are up and everything works. When I fail the primary WLSM, I see all the wireless...

Hi all, I am trying to install CallManager on a laptop for demo purposes. I have done it on a "non-approved hardware" machine many times before, but I have not come across this problem before: Win2k Server is installed Service Pack 3 (standard MS bui...