To anyone that can help with this it would be greatly appreciated. The expressway license breakdown is a mess. After romping around the web last few hours I have a better understanding of what goes where but not completely sure. I was hoping someon...
Forum Posts
Is there a way to schedule a TMS externally hosted call to connect to a VMR with a PIN code? I've tried putting the PIN the in the extension field in Connection Settings tab for the participant with no luck.
We have a Cisco Webex Room Kit registered to CUCM 12.5. The environment also has VCS C and E 12.5. The Room Kit is using SIP currently and we need to make calls to it from a number of Lifesize video devices currently using H323.What would be the reco...
Hi,I have video devices like (spark room kit, kit plus, SX80, kit mini etc.), these devices are registered to CUCM ver 11.5.Requirement:There is an external H323 video conference call, and I want to dial a public IP address from these devices over ex...
Dear all Does someone has the Idea what is the api command to set TlsVerify to Off ??is it only possible via Web Interface ?Thanks for any Feedback. Best RegardsGeorg
Hi.. Can anyone tell me if the CS-KIT-MINI-K9 comes with the touch10 device and wall mount kit ?The specs for the device mentions a "Cisco webex device Subsciption" available for different time periods, What is this and is this needed ?Thanks for any...
we newly purchased one cisco spark kit mini and we are not getting Call and share option on Touch panel and on TV screen. please suggest.
I have an SX-20 Telepresence device with two TVs hooked up. Users typically don't use the camera for Webex meetings. So when we join the sx-20 to the meeting, it shows the active user speaking (or their cam if it's enabled) on the one screen, and t...
I am having an issue, on TMS15.9 / TMSXE 5.9 if the meeting organiser books say 2 VC room bookings and also adds the scheduling mailbox all works fine, gets the notification back from exchange saying the room bookings confirmed then receives an email...
Hi All, We recently purchased some Cisco WebEX Room Kits and a CMS to integrate into our current CUCM cluster. We haven't installed the CMS as of yet, i've just registered the Room Kits to verify functionality and services. We attempted to dial into ...
We have a dying C60, replacing with a SX 80 with a Crestron controller. We just use the Crestron to route signals, no camera controls, we still use the C60 remote to send content after the Crestron routes everything. The install company is trying to ...
Hi - looking for guidance on this migration. I guess we need to enable the web bridge component on our CMS call bridges instead?
Resolved! MX300 Endpoint Standalone
Quick question, the MX300, can this endpoint make/receive calls without being registered to CUCM or VCS?
What's the best solution for Cisco SX10 Quick Set's "audio input" (4-pin mini-jack) when there is more than 10 users during one "video session" in the room and there is need to have good sound transmitted together with video?I just found that suggest...
Expressway (MRA) v X12.5.7 Based on a request from our security department, we need to disable TLS v1.0 for MRA on our Expressways. We were able to disable TLS v1.0 globally -- but it still looks like that applies only to SIP but not to MRA. We can s...
