So into a call for a few minutes and the system crashes and goes into maintenance mode. A few minutes later, its back up and ready to dial back in to the call. Also happens just in a local presentation. Is this common and/or is there a fix? Thnx
Hi all,
i want to query SQL server, to retrieve information about registered devices in CallManager and VCS-C. From Cisco TMS i found views displaying registered device to CUCM and VCS. What i'm looking for are tables and columns to build a query aga...
Hi,
the below command does not work in the 4000 ISR ?
fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback cisco
Do I need this ?
What is the equivalent command for this
Thanks
We have SX20/80's deployed with Touch 10 and are in the same VLAN. Recently I started seeing some of the touch panels losing network configuration (static IP. subnet mask and default gateway) information and losing contact with Codec. I have seen thr...
So can a couple of old Tandberg TTC8-01 be used for anything? They have HDMI outputs on it and power supplies are not a problem.
Just seems like such a colossal waste to toss/excess them given the optics are probably just as good as the newer CISC...
all,
has anyone already experienced a loss of network configuration on Touchpanel 10 connected to SX20N running running ce 8.2.2 after panel is disconnected from network / power?Any experiences made so far?
regards
andy
Hi;
I created a new zone in my old VCS version 7.2.2 A524 ***** to interconnect it with a new VCS version 8.10.x for H323 it's ok but for sip tls I have this message that s displays "TLS negotiation failure".
I check the server certificate it has exp...
Dear All,
is anyone aware of a solution to control access to CMS spaces via WebRTC from the Internet?
We deployed WebRTC proxy solution over Expressway; the problem is that finding out the URL (which is an easy-to-find "join.company.com") basically a...
So we are about to deploy CMS WebRTC over Expressway as people would like to use the Webbridge over Internet. We have the VCS-E with a single NIC and single CMS server with all the configurations in place. WebRTC internally is working fine. I checke...
We have a CMS v2.2.8 installation with several spaces protected by PIN. The PIN input timeout is so fast that most users cannot make it in when dialing the space for the first 4 to 5 times, especially when dialing from a Webex Board. Therefore we nee...
Hello, We have a Cisco Telepresence server which is currently set to run 720p 30fps video quality and 720p 5fps content quality. This all works fine but if we share content and this contains any animation or mp4 type files then the participants exper...
Hi
Current environment provide interop to Microsoft enviroment SfB
TMS 15.5 / TMSXE 5.5
CMS latest 2.2
350 Cisco EP's MX /SX
Meetings to be booked using Skype Meetings in outlook
Meetings will be hosted on AVMCU
Can automatic connect be used to ...
Hi,
I have the below scenario
Without cisco meeting server , it 's possible multiple calls like one sip call and at the same time call through pstn
Thanks
