TelePresence and Video Infrastructure

Hi,Have a EX90 with  TC5.1.2.289652 and a SX20 with TC5.1.3.292001 software.We set the QoS to be 34 for video, 0 for data, and 46 for audio but on restart of device these 3 values get all set to 34.CUCM is set to use AF41 (34) for video and Teleprese...

We have a new CTS-1300 system with a presentation cable which has a VGA connector on the user side and a DVI connector on the codec side.  Currently the room has a 1 1/2 inch conduit installed under the floor between the conference table and codec.  ...

Hi,I hope someone can just point me in the right direction here.I have a VCS-E ---- F/W ----- InternetI can make a succesfull H.323 call to another IP out on the internet.But when I make a SIP call it fails under the call history it shows as leaving ...

DX Series seems to only handle either a HDMI input from a laptop or a HDMI output to a monitor, but not both.I've tried this on several DX70/80s but it doesn't do both at the same time. Is there a setting I'm missing?I don't want to keep unplugging H...

Can C-40 codec's 2nd camera input (HDMI type) connect with Panasonic PTZ camera AW-HE60HN/HE? Just video source only via HDMI, no control require.

Is there an easier way to switch between the PC input and the Phone application on the DX80 other than using the input button on the front of the DX80?  I find it cumbersome to switch constantly when using the DX80 as my primary monitor.  Or, is ther...

Has someone configured multiway with conductor and VCS using a format other than the {username}.meet format as explained in the configuration guides? Are there any other wildcards/regex that can be used other than {username}?

Hello,I have an issue with all the EX90s being Call Rejected when connecting to Telepresence MeetMe room - all internal to Corp network.All our C40s, SX20s all connect to the MeetMe rooms, but all the EX90 failing.VCS-Control is stating:2014-04-12T02...

Hi,I listened the DX80 support the focused mode on mic, that would receive the sound on the front of side and ignore the other sides' sound .... Anyone tried this out? I tried and look like not working.

As per a previous thread, I've got Conductor + VCS + TP server working in a semi-test environment.  The plan is to use this for Multiway.The challenge I'm facing now it to be able to roll out a multiway address to all my endpoints.  From what I can g...

Hi all, My scenario: SX10 --> CUCM --> Expressway Core --> Expressway Edge --> Internet (Public) --> SX10 I configured SX10 into LAN.But in the internet,i don't know how to configure it with Expressway Edge.Because in menu of Device, i show that it h...