HiSomehow on all my Movi users there's added a H323 line in the adress space (see attacment) does anyone know how to remove that since the "Sip:my.address@" is making problems for me when importing phonebook to a ldap serverRegards
Hi,We have several TC devices (such as C60's, C90's and SX20's) registered to CUCM. The phonebooks on those devices appear to be in the order of when the contacts were added to the directory (oldest at the bottom and newest at the top) rather than a...
we have Cisco VT camera iii and we are using generic windows driver we can not install driver properly.can any one help us how to install the proper cisco VT Camera III driver or tell location of driver where we can download the d...
Hi,Wer'e deploying VCS-Lync integration and having trouble making Lync to/from MCU calls to work. It seems to be an ecryption problem as we're getting an "encryption levels don't match" error when looking at the search rules. We have setup the Lync s...
Dear allI ahev a general questions regarding the Migration from TMSXE 2.3.1 to 3.02 with Excahnge 2003.Is there a problem to do that? or could be maybe a risk that I'm loose all my Calendar entry on the Exchange?Is it also possible to make an upgrade...
We are working with a Lync Gateway VCS solution (B2BUA) and have calls working between Endpoints and Lync. We also have calls working from the Codian MCU to Lync. But calls from Lync to the MCU fail. The VCSC that the Codian is registered to shows...
Looking to see if there is a way to upgrade EX90's set in Provisoning - the users are work at home and some are Execs - iT would be diffcult for them to perform the upgrade TMS 13.2.1 TMS Provisioning ExtensionVCS -C and VCSE 7.2.1 Existing EX90...
Hi,We have a recruitment from one client to integrate VCS with Avaya CM5 ,so that uses can join conf. call from Avaya IP phone and it has to happen over H.323 as client don't have session manager.We created H.323 trunk at Avaya end and neighbor Zone ...
Hello,recently I installed Tandberg SX20 Codec successfully.Camera works good and Calling other site's EX90 is good.but, When I called to Polycom HDX 8000 has problem. received packet is perfect. there is no packet lossbut, transportation packet is p...
Hi;I have an issue wherein the media fails on analogue calls in one direction only.Analogue connected to fxs port dials out over SIP trunk to IP handset on CO switch. After 30 seconds media from analogue fails but still works from CO switch.voice-po...
Friends, i have a challenge in adding Tandberg Profile 52 dual to TMS and getting the Error "object reference not set to an instance of an object". TMS is running on 13.XProfiel is on Tc3.1.1but we have the Same Combination of Devices added in TMS al...
I'm attempting to update my firmware to version 6, but when I click "upload" the wheel keeps spinning and spinning. I've successfully upgraded 5 machines using the GUI method but this one is stubborn. Do you think it's a firewall issue? Also, I can o...
anyone experience with a problem cannot access VCS web management after upgrading VCS from release 7.1 to 7.2.2? It seems that the webserver is not starting after the upgrade is completed. I have two VCSs and one of them upgrade without any issue.
Hi, We are planning to deploy VCS Expressway Cluster for a company which have two sites. Each site will have one VCS Expressway. Dual interface and NAT will be used. I would like to know the list of ports that is used for cluster communciations. The ...
