TelePresence and Video Infrastructure

Hi everybody !I meet registration problem on a   VCS Control (7.1) with a terminal (TC 5.1.4). I made the configuration normally but I have this error message bellow :I tryed to change the policy in the subzone of terminal like "treat as authenticate...

                  I would like to know if it's possible to limit the ability of codec C20 (TC5.1.6) to make an audio call when a video call is already active.  I tried to put "Multipoint Mode" option to "off" but without success.  The C20 is still ab...

Anyone else having an issue with the fact that with TMSPE you now have to buy findme if you want properly working phonebooks?I ran into this when creating a new instance of TMS with TMSPE. With out findme the phonebooks do not work properly. They are...

Hi,Just looking to get some feedback from other users on which codecs you have enabled on your MCUs in a multi-vendor environment, we've had some issues recently so we've locked it down to the below, I appreciate there probably isn't a 'safe' configu...

Hello!Can you please help me - I try to interop VCS-C and CUCM following Cisco_VCS_Cisco_Unified_Communications_Manager_Deployment_Guide_CUCM_6-1_7_8_and_X7-0.pdf but it not works in both ways. When I try to locate CUCM nomber (77xxxx) on VCS-C, it t...

Hi team,a customer is using a lot of Transforms in VCS-C (X7.2) to reduce manual faulty dialing from endpoints and to force communication via SIP protocol.So for each new Cisco VC-EP (Profile and EX-Series) customer creates two new Transforms.(It's a...

Dear SirI need advice and suggest about my configuration between Gatekeeper and Bordercontroller.i have a problem in zone status . i have notice that "No Gatekeeper reachable" in Gatekeeper and "No active client" in Border Controller.i attach some ca...

Hi,I would like to use the ISDN feature of my Tandberg Edge 95. I have noticed it is greyed out in the menu system, not allowing me to make calls via ISDN. I have the ISDN ports on the back of the Tandberg. Is it possible to find out what my bandwidt...

Hi all,Any knowndates for new SW releases of TP Server and CTS-MAN.TP Server – Next release of 3.0 = TPS 3.0 Maintenance1.CTS-MAN – 1.9.1 versionWe are waiting for fixing BUGs.Many thanks,Josef

Hi,I have a integration with Lync and VCS using B2BUA. But I´m with the following problem :I can call lync clients using the E20 phone, but I can´t do the inverse... I can´t call E20 using Lync client.  When I call, the lync client shows "connecting ...

Hello:I am working with a user that has installed the free Jabber Video client on their PC laptop. According to a speed test, the workstation's Internet download speed is approximately 17 Mbps. The upload speed is 0.43 Mbps.The user is unable to see ...

I just did an upgrade for a customer on their VCS Control from x5 to x7.2. Customer has neighbor zones to three regional CUCM clusters, (US, EMEA and APAC). Customer reports that video phones registered with the EMEA cluster (CUCM 8.6.1) drop after 1...