TelePresence and Video Infrastructure

Can anyone tell me how long it should take to unbox an MX800 (single screen) endpoint and mount on a floor stand (wall supported so needs holes drilling in wall) please? The network and servers will be pre-configured and done remotely once connected ...

Can anyone tell me how long it should take to unbox an MX800 (single screen) endpoint and mount on a floor stand (wall supported so needs holes drilling in wall) please? The network and servers will be pre-configured. I am just looking for the engine...

Hi guys, Does anybody knows something like that? I have test  mic with vu meter connect in mic01 (blue port) and it works fine, however when trie  to connect the same mic in port mic02 the vu meter did not work. Should I connect two mic in the port...

I have MCU 5320 runing latest versioni want to upgrade MCU to telepresence server It is possible i know but please guide me How to procedd on this or we need to buy any licenses to fulfill this requirement. Thanks and Regards Sushant

Hi all, Just want to ask that , when i show run on the cisco WS-C2960-24TC-S  there are few command that i don't understand .  mls qos srr-queue input cos-map queue 2 threshold 1 1mls qos srr-queue output cos-map queue 3 threshold 1 0mls qos May i kn...

Hi, This is a genral question. So currently we have a setup where all the users are able to book their own meetings on IBM Lotus Notes ( we have the Notes TMS integration packaged installed) so when they create a new a booking they can choose the st...

Hi, Does anyone know where can I download snmp MIBs for cisco video endpoints sx series ( sx20 and sx80 etc) ? Thanks, Nick.

Dear community,  After a successful VCS Lync Gateway B2BUA with Microsoft FEP deployment for Cisco video to MS Lync 2013 client interoperability I am experiencing the following problem / lack of information in the deployment guide. I want to enable M...

We have seen multiple instances of C40 codecs crashing and rebooting when connected to someone trying to present from Avaya's Scopia desktop client. Has anyone else experienced this?  This doesn't seem to happen with our SX20 or SX80 models, just the...

Do the GPIOs on the SX80 have a galvanic isolation (including the GPIO-GND and +12V) against the rest of the device and it´s power supply? Or do I have to use an extra optocoupler or relais to achive this? thanks Tino

Is it possible to move or remove the icon that cuts into the middle of the screen when a SX codec is connected to an audio only participant? When we do presentations in some of our meetings, this icon pushes out into the presentations and results in ...

Hello everyone, I have a SX80 Codec using a Cisco CTS-CAM-P60 the default camera that comes with the system.  My setup is Codec - Vaddio OneLink - Camera but I having a weird issue now twice and would like some inputs if anyone else has run into thi...