Hello
i have a Prime infrastructure on UCS in one network and i want to move it to another network with a different subnet.
i am not a UCS expert and i want to know which IPs i need to change (ESXI etc..) and how can i change them ?
Hi everybody,
My system has a configuration like below:
Blade Server: UCS B200 M2 (Model: N20-B6625-1) with mezzazine card M81KRHost OS: VMWare ESXi 5.0.0 - 623680VM-to-SAN Network Connection: <(Windows Server 2008 R2 SP1) on an ESXi5.0> Blade Server...
I am going to move a Windows server from one chassis to a new one and they are on different domains. OS is on local disks and I have no scrub policy in use on it. It has iSCSI drives which are configured within the OS. I’ll expect the OS to find new ...
I have a customer with B200-M4 and VIC1340 and one 1300GB Fusion ioMemory3 PX.
The Fusion-io card flags „PCIe Power over Budget“ Errors.
Spec Sheet for B200-M4 shows this as a certified configuration.
I found below for C-Series servers.
Q. does this ...
I have a number of B230-BASE-M2 servers with the End of Support M821KR adapter.
The last replacement spec I saw was the VIC 1280...and that was about 3 years ago.
Is there an update to the appropriate replacement VIC? Thanks.
I'm trying to set the time correctly on our UCS. When going thru the scope instructions for "set timezone" and pick the correct options, the last option is to confirm the time is correct. However, the time shown at that point is incorrect.
We have...
Hello.I have the following question , did anybody setup the In-Band access on Fabric interconnect ?In Cisco UCS Manager GUI Configuration Guide, Release 2.2 I can’t find it and from other source the same...Have anybody practice in such configuration ...
New install 4 blades. 3 of them are working fine KVM Keyboard is ok. On one of them there is no keyboard input translated to the blade when using KVM. Please advice.
Hi guys,We are doing a bare metal install and going to have 2x300GB RAID1 and 2x300GB RAID1 and 3x600GB RAID5.When I look in the Local Disk Config Policy I have the option of choosing RAID level but how do I decide which HDDs goes with what RAID?Than...
Not sure if I'm missing something, but it seems that UCS doesn't detect reboots outside of the CI environment.I'm updating the firmware on the B200-M3 and M4 blades and I have the User Acknowledgement set and the blade is sitting waiting for me to a...
