Voice Systems and Accessories - Small Business

Dear Geeks.. I am a beginner to VOIP technology, appreciate your assistance in achieving the following :Hardware : SPA3102Free PSTN Line Softphone : not yet There are two requirements Primary: If anyone call a local number  it should ring a softpho...

I have noticed that the SSL VPN client capability was added to the 7942, 7945, 7962, 7965, and 7975G phones in phone load release 9.0(2). This feature is also supported on the SPA525G phones. The release notes for this phone load release can be found...

Hi Friends,Does anyone of you have a simple how-to about configuring the UC with jabber?We have the latest release on our UC540 and want to use jabber on our windows 7 and windows 8 clients.Thanks in advancePatrickSent from Cisco Technical Support iP...

Hi:I have UC-540 (uc540w-FXO-k9) systemw ith CCA3.2.3, CME 8.6.5. directly connect to Internet.I get a request to support 2 remote user work from home with Cisco phone. Both of them are working with softphone now (Cisco IP communicator with Cisco IPS...

Hi there,I'm new on this forum and also new on Cisco community.Just 18 years of engeneering in computers, software and networks... We're looking for a standard configuration of an UC540 / Bri connected to two France Telecom/T0.All the configuration o...

Good day, ladies and gentlemen!Cisco SPA502G not updated above 7.5.1a.Fact. release notes that in version 7.5.5 fixes a bug with the encoding names in the address book in Russian, and update your phone to a version greater than 7.5.1a does not work.P...

good morning I have a  phone new  SPA509G ,  with factory settings, turning on this message appeared on the LCD screen that leaves SOS PhoneInRecoveryMode completely inactive on the phone, I need help to solve this case.thank you all.

HelloI am trying to configure SIP trunk requiring registration and auth id from UC500 with following config:sip-ua credentials username 3804450283999000 password 7 XXXXX realm YYYYY authentication username 5028399 aut password 7 XXXXX retry invite 2...

I've got a PBX system  and 8 Cisco SPA504G Phones.I'm trying to configure the unused line keys on the phones to be Busy Lamp Field and Registration User PBX.This is the setup I used under the 'Phone' tab for each unused Line Key:Extension:           ...

I have a UC540 FXO with two PSTN lines.How can i configure so that telephone calls always use eg. PSTN 0/1/0 and Fax machine always uses PSTN 0/1/1.Now when making a outgoing call the UC540 alternates between the two PSTN lines (longest idle?), causi...

HiWe have a UC560 with all outbound calls via SIP. When the SIP was initially setup (UK) they associate a test number (which remains with the SIP trunk) before the main 'live' number is ported from ISDN2 to the SIP. Within the UC, I'm sure that I hav...

Dear all,please consider the following setup:In the office, an UC560 is utilized as PBX. The phones are in the 10.1.1.x Subnet (VLAN 100). The UC is connected to the local LAN at 172.20.1.240The WAN Port of the UC is connected directly to the ISP-Rou...

We have a client which would like to transfer calls using the directory feature but experiences a timeout when no digit is sent within 10 seconds. This has been discussed twice already (here and here) but none of the answers appear to deal with a SIP...