Voice Systems and Accessories - Small Business

Hello Experts,I have a CME and UC500 setup for SIP calls. I can make SIP calls from CME to UC500 but not the other way around. here's the output of relevant configuration. Any help would be highly appreciated.CME - 3xxx UC520 - 2xxUC520dial-peer voic...

Salve sono un nuovo utente del spa 3102  molto vicino a gettare la spugna, vedo su internet che ci sono scuole di pensiero diverse riguardo i parametri di configurazione, penso che questa siala sede più opportuna per avere riferimenti più "seri" ho a...

HelloI'd like to configure my PAP-2T gateway to use it with two phone provider.Exactly: I'd like to use my outgoing calls to mobiles through one provider and to mobiles through another.Anyone could tell me how to do it?TIAmarek

Hello.I have SPA9000 system with SPA502G phones and SPA500S on couple phones. I was wondering can I configure SPA500S keys for call park? If yes, how.Thank in advance for any answer.BRSloba

Hi CommunityCan anyone tell me, witch POE class the SPA500 phones "is in". 0,1,...I only have the powerconsumption data

Hi, I have 525g with last firmware, and a attendant console, in the attendant console I have any extensions with blf, and I want to trasnfer a call using this keys.I want to do attendant transfer, so I received a call, push transfer and softkey exten...

Noticed an issue with a customers UC560 where when there is silence on the line (eg both parties don't speak) where you get this pulsing static (best way I can describe it).  Phones in use are 525G units running 7.4.6.  UC560 is running the 8.0.4 sup...

HiI just noticed recently that my phone kept rebooting after resync. In the config, i set the resync period for 86400 sec or 24 hours so i didn't pay attention to this issue until i came to my desk and found that my phone was rebooted. Then i change ...

Are there any 3rd party ACD products that work with the UC540/560?  We have a potential customer with a small call center of 6-8 people. They want the ability for everyone to see who is logged in and if they are on the phone or not.  They would also ...

I have a city for a customer they just purchased a UC560. In the city they have two totally separate networks, one on the Police side and one on the City side. I have installed a 24 port POE switch on the Police side and a 48 port POE on the City sid...

I have 4 lines configured - one line to one VN. They are tied into one trunk line. When I call the first or primary number, all calls hunt properly to all 4 lines. When I forward a pots number to the primary number only one call connects - all other ...

Hello everyone, I experimented unsuccessfully with functionality SNR. When I configure, SNR on a phone and I setting the second phone to ring after a while it works very well if there is another internal SCCP phone or to an external number as a fixed...