Voice Systems and Accessories - Small Business

Hi all.I am in Spain at the moment and trying to set up a SPA3102 so that I can make VOIP calls (using freecall.com) but also be able to make PSTN calls from the same phone. What I ideally want is to be able to use the PSTN line for national calls, a...

Dear Sirs,we use few cisco spa509 and one spa525g with 3cx PBX. All settings we submit through autoprovisioning with auto-resync timer in 24hrs.Today spa525g starts to update .xml file every 10 to 40 seconds. It looks like - make unregistered all lin...

ok here is my set upcable modem ip 173.163.87.166 one wire to adtran 4305 router eth 0/2 ip 173.163.87.165 second wire from cable modem to uc 520 wan port 173.163.87.161the adtran is the main router for the data lan eth 0/1 ip 192.168.1.5the voice ne...

Hi,Hi,I have a UC540 configured with a Skype sip trunk. The trunk is registered with Skype. I'm unable to make outgoing calls. I configured the trunk using the latest version of CCA and followed and updated PDF doc for the Skype config. Incomning cal...

When I did a software upgrade using the CCA, it failed when it was restoring the CUE data.  Afterwards, when you tried to access a mailbox, it acted like all mailboxes were new.  I backed up the system before the upgrade so I did a restore.  It resto...

Using the CCA 2.2.6 , i'm trying to find a way to lock down a phone that is used in an unsupervised area.  Basically it needs to dial 911 for emergencies and if possible enter a PIN to get an outside line.Any suggestions....

We have a customer with a UC520 than randomly rebooted.  It only happened once so far.  Are there any error logs I can check to find out why it rebooted?I noticed the closet that stores the UC520 is pretty hot.  That might be why it rebooted but I ca...

Any information or design guide for new Cisco Smart CallConnector Operator. Is it supported for Callmanager Express?http://www.cisco.com/en/US/prod/collateral/voicesw/ps6882/ps10585/data_sheet_c78-568488.htmlwill it be supported for configuration thr...

After three weeks of brutal agony, a solution....Problem: outbound calls from UC540, all SPA525G2 phones through carrier using Metaswitch failed to pass DTMF to PSTN.Metaswitch published two different config guidelines around the UC500.  The Doc ID 9...

Hi all, hope if you can help me. I have a CME with ios Version 15.1(1)T2, RELEASE SOFTWARE (fc1).I already check everything and I can't find the problem.I have a BRI configuration like this:************************************************************...

Hi,I have UC520. The voicemail is not working. I have upgrade it to ios: uc500-advipservicesk9-mz.150-1.XA3a  and erase uc520's configuration to factory default one nothing changed.I have CCA 2.2(6) and I am always recieving same attached error.When ...

Dear CCA team.! 4 TAC calls and CLI requirements with standard CCA configto make advertised features work! Nothing out of band! 1) When doing a new turn up the wizard will launch in aminimized window on win 7.  Not knowingthe wizard is there and be...