VPN

Doing a traceroute from my cisco switch (happens with the pcs too) through an IPSec tunnel between a pix running 6.2 and 7.0.2 code... appears to scramble the response ip's.... I am getting non existant ip's for responses... does this sound like a b...

Does anybody know if this is possible.I need to create a site to site VPN between two Pix's.The first Pix will encrypt traffic from it's inside Interface. The second Pix will encrypt traffic from its DMZ.Once the tunnel is set up I would like to tran...

Hello,is it possible to establish a LAN-to-LAN VPN between an IOS Router and a PIX using "interface tunnel" on the Router. If it is possible, what should be configured at the PIX. Reason: using dynamic OSPF Routing over simple IPSEC-VPNs without GRE...

i know 7.0 can support equal cost routes i find form 7.0 config document.http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a008045247f.html#wp1047900i wonder if pix6.3 also support this fethure or not

Hello all,I recently configured a small PIX 506 firewall to terminate internet based remote on-demand client VPN connections (we are using the Cisco windows PC client software) and all is working well. Hovever, my customer would like to see a login w...

I have clients coming in from a cable modem - one IP. Is there a workaround I can do to allow multiple people to come in from one IP?

Hi,I would like to establish more than one VPN connection from the same server? Where I'm the client and I want to connect with different networks from my single server.What is happening is that it was requested that I dedicate a server for each netw...

I am trying to connect a remote vpn client using the vpn client software, with my router. The client has a firewall and nat on their side.The client is able to connect and recieves an IP address from my IP pool, but it can not send or recieve traffic...

I am trying to put in the line "fixup protocol pptp 1723" on our firewall. I tried this command line and got an error "bad protocol pptp". I also tried going through the graphic interface and there was not a PPTP available under the Fixup section.W...

Hi,Need to know whether is it possible to define an ACL per group/user basis for IPSec client??Anyone can provide me some sample or URL??Thanks.

dear siri am trying to configure ip tunnel in cisco pix 515 i get the configuration from our configuration our customer it but i am not able to establish the connection. can some body help. here is my configuration as per per our client and debug tes...

Im trying to connect to a 3000 concentrator at work from home through a pix 506e. When I try to connect, I get the authentication prompt OK, I enter my credentials, then it says "securing the communications channel" and a couple seconds later it just...

Heya,I am a last year student at a Finnish polytechnic and Im (hopefully) graduating soon with a bachelor's degree in business and administration. Im doing my thesis work for the school in relation to a Cisco Systems ASA 5510 and adapting it to manag...

Hi,Any info on this issue will be greatly appreciated, my level of knowledge is low when it comes to VPN’s. Here is my current issue, I currently have a PIX 506 with VPN enabled on it, some users connect remotely with the Cisco VPN client software. N...

We have a central router connecting to several remote sites. Central router is configured never to dial out.One of the remote routers has been working ok via a BRI for several months.We then changed it onto a new BRI - all configurations staying the...