Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Hi, We're authenticating users through an Windows 2012R2 NPS policy server. This works fine but when a user changes his password in the Active Directory the client still authenticates with success instead of prompting for credentials since these are...
Hello, I get a daily Worst Air Quality AP Prime report emailed to me and the odd AP will say it's value is 1, but most say they are around 99. I understand 1 means that it's had some Air Quality issues that day, but what could it be? Is they a way...
Hi, How I some question for the cisco 2802 mobility express. 1. I want to Set up a temporary guest WiFi user on cisco 2802 mobility with expiry time. 2. Can I authenticate with Radius and LDP server ? Please reply to my queries. Regards, Dee...
Team, We are designing this network for a client and the AP selected were 1852. Since 1852 have 2 x 1G ports , we decided to do a LAG with the access switch. The access switch selected was SG 500X. The deployment guide for 1852 says that we n...
Hi, Is there a way for flexconnect AP in standalone mode (disconnected from WLC) to do local PSK authentication for an SSID? I'm looking for the configuration guide on this and not sure if "ap local authentication in flexconnect profile" is the setup...
I have a WLC with different AP.I want to replace the "physical" controller with a virtual one: what is the best way to move the AP on the new controller? In other words: how can I make the "join" to the new vWLC ? Best Regards C.
I am getting Discovery request decoding with subnet broadcast and wrong AP IP address as the error on my WLC controller when my AP tries to join. The management interface is on 172.16.0.253 port 1. Port 2 is my other side of the network which is 172....
Dear all specialist, Good day at all, I want to design my wireless network where WLC located in central office. All AP from branch and central office connected to WLC via data network. So what process should I follow for this solution. Regards MEHED...
Is there feature in a 5508 WLC that can enable a capture portal that requires someone connecting to the guest wireless network to have to register the device? Or would this require a third party application?
Hello every, According to Cisco commands reference, we could add MAC into exclusionlist manually, can anyone advise what is the consquent of this behave ? Is it the same as the MAC be moved into exclusionlist dynimically and will be remove from list...
Dears, I have installed a 5520 WLC with 2x1G/10G SFP module, When installing a GLC-T 1G and reboot the WLC it is working with no problem at all, But when i install SFP-10G-SR-S into the Ethernet module the perform a restart, The port does not blink ...
I have four cisco aironet air-lap1131ag-e-k9 access points. How can I unite them in a seamless wifi network? Can I use router as a controller for those acess points?
We have been using Cisco Systems VPN Client Version 5.0.07 on Windows 7 and an RSA key Which version can we use with Windows 10 ? Richard.Lalonde@crl.com
Looking for some ideas - I have a brand new network that I am installing. I have 5 Cisco WAP561 access points, a Cisco 8port POE gigabit switch and a Linksyst EA6900 router. I was able to go thru the setup and created a Group with the AP's and disc...
Users have the following issue, after being connected for a couple of hours and having full connectivity they fall into a limited connectivity and cannot ping their default gateway. The only workaround for this is that users disconnect and reconnect ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 12-09-2025 06:25 PM | ||
| 12-08-2025 01:34 PM | ||
| 12-07-2025 01:43 PM | ||
| 11-13-2025 02:28 AM | ||
| 09-02-2025 03:53 PM |
| User | Count |
|---|---|
| 3 | |
| 2 | |
| 2 | |
| 1 | |
| 1 |