Wireless

Requirement(s):PCI DSS v3.1: 11.1 Implement processes to test for the presence of wireless access points (802.11), and detect and identify all authorized and unauthorized wireless access points on a quarterly basis.PCI Card Production v1.1: 5.7.1.e W...

I have APs in dowloading status and in order to reboot the WLC to set the boot image to backup the APs need not be connected. I wish not to shut the AP ports on the switch. Is the a GUI or CLI command to do this?2504 WLCs with 7.2, 7.4, 7.6 firmware....

Hi,We are using WLC 2504 with internal web auth to users and creating user credentials with time limitation at Lobby admin rights.While user end of session with their login, WLC is not responding. And immediately WLC is getting restart  (or) Hangs up...

i have a client that is asking to connect a wlc to a firewall instead of the core and to move the dhcp for the wlc users from the core to the firewall , is that possible? will the ap still see the wlc? if so do i create dhcp on the firewall then unde...

Dears, I have issue with accessing the Cisco Wireless Controller by GUI if I am connected by any of SSID subnet,but if I connect through any Vlan which is not exiting in Controller or SSID if proxy configured ,it can be accessed...   

Looking for advice and guidance on the best method to monitor Wirless performance of the voice network.  We currently have PI 2.2 installed and am having trouble seeing any data in regards to how the radios are performing woth voice traffic (RTP).-ho...

Dear Cisco,WWe're informing you that we are having recurring problems with a wireless controller ( AIR-CT5508-K9) and its access points associated to it. We  reconfigured stand alone Aps (AIR-LAP1041N-E-K9) to lwapp firmware,succesfully adopted them ...

Hi,SSID with web authentication enabled , (redirected to ISE) , wireless client summary shows 'WEBAUTH_PEND ' , How do we know that  , user did not try to open a web page (after connected to the ssid user did not take any acton ) or due to some reaso...

hi ,has anybody used Cisco 3650 switch as WLC ??Can anybody assist me ? Zeynal.

Hello all New version 4.0.9 posted: Changes20036 AP: Flexgroup has AP included, but AP is not in Flex or Flex-Mesh modeRF Health metric optimization (Cochannel, noise)RF Health summary usability improvementsXLS export in Report Center FixesAP RF Summ...

I need make a lab with only WLC and MSE 8.0.110, my machine do not support Prime (need a lot resource).So, there are any MSE command to add WLC?