Wireless

Hi I would like to ask if I can block a user who connects to our network and generates high usage of internet. The problem is every time he clones his MAC address.PS ...( WITH OUT SETTING A PASSWORD ON THE APs AND WITH OUT SWITCHING THEM OFF)THX

I have a Cisco 5508 controller with multiple 3601-3602 APs. Is there a way to isolate clients by MAC address to a specific AP?

Hi, I was curious to know if there is a way to bulk edit our Mac Filter templates on NCS Prime 1.3? In the mac filter under controller template launch pad > Security > Mac Filtering we have several hundred templates for various devices. We are in nee...

Hi Team,I am using Cisco Prime Infra 2.0. I want to find the logs related to LWAP Templete. We have 4-5 templets created. few days back one templete has been modified and the templete was pushed to all the AP's. So i need to know when,How and Who has...

Started seeing this error message today.  Looking for what I can do to resolve this.  Running CPI 1.3                  

Dear AllCould any one tell me the step by step procedure of integrating MSE with prime..?And also what is the minimum version is required on Prime or dependencies if any.Thanks in advanceKVS

Hi,I have been offered a point-to-point configuration to extend our 2602i Wifi network.To replace an existing Psion Wifi connection (100 meters) consisting of 2 accespoints and 2 antenna's I'm offered the following:2x air-cap3502p-e-k96x air-ant2410y...

Hi,I have two ISE-3315 Appliances in production network. I need someone's help to explain, how to make the Secondary node as the primary admin note to reset-config.And then I would like to know how to keep the license files and Certificate during the...

hello everyoneI have an AP AIR-SAP1602E-E-K9 with ios 15.2(2)JB2, I have created several users via CLI with different privilege and can access with them through CLI without problems, but if try to log in via HTTP only users with level 15 can do it. O...

Hi all,I need hel pin configuring Bonjour on a 2504 controller with 7.5.102.0 fw.The controller is connected to a 2960S switch with 15.0(1)SE2.The antennas, all AIR-LAP1242AG-E-K9, are connected to this and other 2960 (same sw).I followed step by ste...

Hello all, I have multiple remote office locations and I have implemented HREAP using central authentication and local switching. The offices have 3 vlans. switch/router mngmnt, Wireless management and the office vlan. The access points are 3502I. Th...

I have two SSIDs on my Cisco 1242 APs. On one of the SSIDs i have clients that will constantly broadcast data (required).Will the brodcast traffic reach my other SSID? If so, is there a way to avoid it?Will creating a separate wireless VLAN on my AP ...