Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I have an AP1231G access point and I am trying to configure it as a workgroup bridge (i think is what I need). Here is what I have. In one room I have a wireless router and in the other room I have two computers, switch and AP1231. My goal is to make...

I have a question about 802.11n settings. I have the default radio channel set to 11 and the channel width set to below 40 MHz.Is this correct or should the channel width be set to above 40 MHz?I'm finding a large number of receive CRC errors. Should...

mgregory by Level 2
  • 5093 Views
  • 25 replies
  • 0 Helpful votes

Hi All,Hope to you a very happy new year,I have an (AIR-CAP3602i-E-K9) and I tried to join it to WLC 5508 but I'm facing an error,I get this error from the LAP 1310 console as below:Reading cookie from SEEPROMBase Ethernet MAC address: 60:73:5c:ad:cb...

Hi All,Hope to you a very happy new year,I have an (AIR-LAP1310G-E-K9R) and I tried to join it to WLC 5508 but I'm facing an error,I get this error from the LAP 1310 console as below:Compiled Mon 17-Jul-06 11:45 by alnguyen*Mar  1 00:00:05.289: %LINK...

We have a WLAN that was deleted from one of our controllers a few months ago.  Apparantly the vendor came back and must have the same WLAN rebuilt.  We are using NCS and have the backups.  How can i retrieve just this particular WLAN without restorin...

Can we use a power injector from a 1410 series wireless bridge to replace a failed AIR-PWRINJ-BLR2 for a 1310 series bridge ? I know there is no console port on the BLR1.

Hi AllHas anyone had any experience with the new AP1600 with external antennas that was released a couple of months ago.The data sheet shows only 3 antenna connectors although it's a dual band radio AP.This suggests the need for dual band antennas.Ca...

Hi AllI've heard on the grapevine that Cisco has an AP that will work in a cluster with one of the APs working as a controller.I haven't heard this at any PVT and can't find any information anywhere.Does anyone have any knowledge of this?RegardsRoger...

Hi All,Anybody knows if the Peer to Peer Blocking in WLC can work for inter-WLC traffic? (e.g. WLC-1 and WLC-2 both have SSID1, after p2p blocking action is enabled, can a client under WLC-1 SSID1 communicate with another client under WLC-2 SSID1?)Th...

teru-lei by Level 5
  • 2639 Views
  • 7 replies
  • 0 Helpful votes

I have a question to migrate a customer from a 2106 controller to a 2504 controller.Can I use the configuration file with both controllers having the same version?Or is there another way not having to do it again manually?The old configuration is OK,...

Erik Boss by Level 3
  • 2675 Views
  • 19 replies
  • 0 Helpful votes

Hello guys,Need some assistance on DHCP settings.We currently have 2 DHCP settings on our controller.we have 1 Vlan Corporate which points to our Internal DHCP Server and the other GUEST we point it to our controller to serve out IP Addresses.Issue w...

JDMJeffy84 by Level 3
  • 10554 Views
  • 8 replies
  • 0 Helpful votes

A week ago we upgrade from the 7.0.116 software to 7.2.111.3.  Since doing that we are seeing a lot more clients drop connections and be unable to re-join.  The wireless network KEY (WPA & TKIP) is on the machines and stored.  When the connection dro...

rsaeks by Level 3
  • 2455 Views
  • 3 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card