Wireless

I want to use Cisco VMS to manage my IPS and firewalls.A also have two routere and five switches in place can i use the same software to monitor and manage them or I need separate software.

I have multiple ap's in a library, all settings left to defualts(mostly) POE, primary antenna only, random clients lose connection and cannot see ap and have to be re-added by local admin before they will see ap again. any suggestion??more info??

HiI trying to make policy work under windows 2000.I downloaded the latest version 2.6 of aironet client driver for CB21AG and PI21AG but it still doesn't work.In the release notes it says that there is a hotfix for delaying the policy and there is a ...

We are just setting up a new Wireless network at our new campus. We have 1131AG WAPs, a 4402-25 Controller, and WCS. The wireless has been working for several weeks, and today I was adding several new APs for a new area of the campus. Anyways, long s...

Does Cisco have Non Line of Site Wireless Bridge?

Since my 1242s came with power supplies I dont need the power injector right? I ordered two solid dishes to shoot a shot 3 miles away from my Internet dish here and two yagis to shoot a shot 1/4 mile away. But now they want me to hook up a place to t...

How can we find which controller an ap has disassociated from when WCS reports the following error: AP 'AP0014.1ced.43ec', interface '802.11b/g' is down on Controller ''. ?It looks like "owner" may be the way but how do you configure "owner".

Using Network Assistant 3.0, my new 1240AG WAP cannot be joined to my community... it is reported as being 'unsupported". According to Cisco docs, the 1240AG is supported if it uses IOS, which mine does. Is there a config switch I am missing? How do ...

Hi,I am receiving High Queue Drop Rate Packets Output on the Dot11Radio interface for AP1100 on the deveice fault manager - monitoring console.What could be the problem?I have the virtual interface radio down and the AP is on Root Mode.Can i delete t...

HiI have a problem with an installtion, where i have a br1300 with 2 vlans and on both vlans are wgb1200 connectect (no trunk there!)in the native vlan the clients behind the wgb gets ip addresses but not clients behind the wgbs in the 2nd vlan. i ha...

I like to configuring two BR1400s EAP authentication and Dynamic 128bit WEP(or TKIP) with ACS3.3 authentication server.I think the root bridge could be have EAP seting(RADIUS server, shared secret ket, encrytion an so on) and non root brighe could be...

I am interested in upgrading the wireless system at my home in order to gain better indoor and outdoor coverage, improve security and eliminate the eyesore AP we now have. After preliminary research, it seems either the 1130AG or the 1200 series make...

Is there an update yet that will allow me to use LEAP auth with the Airespace products?thanks!bob

Is there a white paper on how to configure this on the Airespace equipment? I've noticed documentation is horrible with this product. Any help here would be awsome. Thanks

Dear NetPro,i need some expert to advice, when i put encapsulation dot1q and trunk in the switch port. i totally can't get any ip address assign by Access Point. and when i remove the encapsulation dot1q and trunk. i am able to get ip . what does it ...