Hello,
i have in the log
mibd_interface[332]: %SNMP-IFMIB-3-SYSDB : Failed sysdb operation: stats bag decode, err: 'bag' detected the 'fatal' condition 'The specified bag is corrupted'
What can i do?
Regards
Frank
Hi, I have two XRv routers running 5.3.2. One of them (router A) has a BGP session with a Linux VM running ExaBGP which is advertising the Flowspec rule. In this router A I can see the Flowspec rule. I am trying to get this router A to propagate t...
Hi all
I am facing the below issue
RP/0/RSP1/CPU0:ios#admin upgrade hw-module fpd cbc force location 0/1/CPU0 Tue Mar 22 23:15:14.021 UTC
CBC UPGRADE TAKES APPROX. 3 - 5 MINUTES TO COMPLETE
AFTER THE IMAGE IS WRITTEN, THE CBC IS RESET AUTOMA...
HI,ALLwhen I telnet the CRS-1,I use show diag sum ,show led,show inv command,does the 0/13/* MSC fail?I have not seen the machine,is there SIP-800 no SPA card cause the problem? ========================================================================...
Hi, I have two XRv routers running 5.3.2. One of them (router A) has a BGP session with a Linux VM running ExaBGP which is advertising the Flowspec rule. In this router A I can see the Flowspec rule. I am trying to get this router A to propagate t...
Hello,I have a problem using orf (outbound route filtering) on IOS XRv (version 6.0). I am using a simple network, two routers connected together, peering with each other via BGP, on one side XR1 on the other XR2. I would like to use the orf capabi...
Hi Expertise,
Kindly i will install new 4X100GE-LO [LAN-OTN] and CRS-FP400G to operational CRS-16, So what it the steps and preparation to did that right.
Thanks
Hello
I have actually a 4500X with ipbase, but used only as switch (03.06.03.E)
the switch provide few Vlan input and output for ex 50,51 and 52.
50 and 51 provide from PPPoE customer to BNG (asr9k), and 52 provide from IPOE (DHCP) customer alsays t...
How i can do upgrade if i have the TAR file from RSP1
RP/0/RSP0/CPU0:ASR9006(admin)#install add tar net/node0_RSP1_CPU0/hardisk:ASR9K-iosxr-px-K9-5.3.3.tar Wed Apr 13 06:41:45.241 UTCError: Invalid source name 'net/node0_RSP1_CPU0/hardisk:ASR9K-iosx...
BFD session Bundle-Ether with having 100Gig is not coming up and showing admin down. Even the Bundle Ether location is complete different than the confiiguraiton under BFD. But same configuration is working good in 10gig in our production as well ...
I am using local-as feature in version 5.1.1.
Seems not fully supported for iBGP.
here's my config:
router bgp 65068 neighbor 1.1.1.1
remote-as 100 local-as 100 no-prepend replace-as
address-family ipv4 unicast
!!% Change would result in neigh...
Dear everyone,
My Cisco ASR 9010 have these log over and over, can any one have ever seen it. What should i do now.
RP/0/RSP1/CPU0:Apr 3 22:21:00.351 : dumper[60]: %OS-DUMPER-6-INSTALL_PKG : iosxr-gcp-fwding V 5.3.3[Default] Cisco Systems By iox-lnx-...