IP Telephony and Phones

Hello, voip dial-peer get busied out despite of that the sip option ping got responses from CUCM (v8.6) within 1 second. Is there any reason for that? Or mistake in configuration? The second problem is that once the dial-peer 1250 got busied out, th...

There was CUCM 5.2 and MLPP configuration,after upgrating MPLL Domain stop working.What is issue ?How i must configure MLPP on CUCM 8.6 ? On CUCM 8.6 i have  MLPP configuration in device pool,but on CUCM 8.6 this selection absenceCan anyone help me t...

Hello & Greetings. I am using an older c1760 router. When I run the cmd, sh voice port summ, I get no output. Also, while trying to cfg pri-group timeslots, I am getting err msg. Please see the following cmds / output and help me understand. Thanks!...

I have an issue with Pcikup Groups and directed pickup to a siemens Openstage 40S registered to CUCM 9. The documentation indicates that this uses URI and reature codes which are not supported on call manager, but is their a work around??? Please he...

Hi, I need to integrate 8845 video phone to 10.5.2.11900-3 as I can't see it under deviceI'm planning to do a Device Pack update using cmterm-devicepack10.5.2.13050-1.cop.sgnI would like to avoid a SU at this stageAnyone had done it?Any advice?Thank ...

We are getting RTMT alert "Please Check ICT Trunk . On Thu May 05 12:30:39 IST 2016; alert \\10.240.180.6\Cisco H323(IND_ICT_APAC)\CallsActive has occured. Counter CallsActive of Cisco H323(IND_ICT_APAC) on node 0.240.180.6 has value of 0    which is...

Hi All, I hope someone can help me, I have inherited a client that is still running Cisco call manager 4.3 and the cluster has gone corrupt. So we want to recover and re-install the ver 4.3 to give them time to get funds available to upgrade to call...

have configured MRA with Expressways-C/E 8.5.2. The jabber mobile device can make calls ok. However for incoming calls, the jabber mobile device cannot answer. And the internal desk phone (same extension as jabber) continues to ring. The jabber mob...

hello, We have a problem to PARK calls through Level 3 PRI (US). The issue happend when we PARK a spesific call three times (using Direct PARK) for the third time. on each time that we PARK the call we can see that the CUCM (V.11) send NOTIFY to the...

Hi, We are working on an upgrade from cucm v8.6 to v10.5, and previously we´re on the ip phones upgrade of his firmware. But customer has some remote locations with slow links, and upgrade is not possible to complete, and then ip phones stay on a loo...

Hello everybody, Can anyone please tell me a way on how to monitor and collect MOS statistics from CME platform? Thank you very much.

Hello, We currently use Cisco CUCM 10.x, mainly SCCP. One of our departments purchased Selectron IVR. They asked me to create a SIP trunk and assign it to the server. I have done that but am now stuck on how assign a DID for customers to call that wi...

Hi, is it possible to force a call between 2 phones? (sip-sccp) from CLI or EEM/TCL? EDIT: I have a Cisco 29xx voice Router. how do i use TCL to accomplish this?Thanks