IP Telephony and Phones

Have an issue where a user requires an analog phone, but they also need the ability to either put the call on hold (at a bare minimum) or transfer it to another user.  I realize the analog gateways are limited...but this is a particular case where we...

Hello All, We are planning to upgrade a Cisco Call Manager Publisher node from 8.6.2 to 10.5. We want to install a new publisher on a new environment, but we are struggling with some questions.If we install the Pub node 10.5 can we migrate the config...

Hello Community, in section CUCM and CUBE I had try to find a Dokumentation they describe the szenario in the subject, but w/o success.Szenario: CUCM - SIP Trunking - CUBE - VWIC E1 QSIG - TDM PBX.Szenario: CUCM - SIP Trunking - Voice GW 29xx - VWIC ...

Cisco CUCM 10.5 Ad users are synced from LDAP, Users are working on Portal but when they activate DnD option from portal, it saves the configuration successfully but not active on device.Meanwhile when i tried to use this option with a local CUCM use...

Hi All.This time with the question :)Question is regarding EM. What is the impact of enableing EM on a cluster ? I am talking about a cluster with 8000 people on it. Will that add massive overhead ? CUCM version is 8.6.2.RegardsM Karim 

Hi all,   I am asked to help get a Polycom Soundstation 7000 conference phone to register to a CUCM cluster. It's not really working out though, I get the rejected state in CUCM.   These traces show the registration attempt: REGISTER sip:10.58.250....

Hi Team, Need urgent help We have sucessfully installed CUCM 10.5 Pub and IM&presence PUB on VM platform when we try to install CUCm subscriber we are getting an error - network validation failed for both thye serversAlso We have checked all the Port...

Hello I am looking at the below issues which is affecting users only in a team in a specific hunt-group -- When a voicemail is received all the phones could not use the message button on the phones.Voicemail light indicator on the phone goes off when...

Hey Guys The mic wire length is too short with 8831 for a large conf room with multiple tables. Wireless mics don'ship here. How can we extend the existing length. Tried a manually crimped male female 6 pin cable to extend. Didn't work. Thanks. 

Hello,we have a BE6K installation with 2 CUCM nodes running version 9.1.1.20000-5 which we tried to upgrade to version 9.1.2.12901-3. The installation failed with message "There is not enough disk space in the common partition to perform the upgrade....

Hello Community;I have an issue with one 7975 cisco ip phone, it does work normaly but sometimes it is like bloqued with no tone and a black sreen, i've tried to change the switch port and reset the phone but still the same issue.Any one have an idea...

Hii have two cisco ip phones 9951 and i would like to activate vidéo call between themi configured the tw phones on cucm 10.5when i go to  phone  application + accessoires  i don't find cisco unified camera displayed how can i fix this issueplease fi...