Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Dear All,we have a problem in voice quality ,we use cisco as5350xm and use our special software as a PBX. also there is a very heavy traffic of calls which are handled by operators. but the only problem is the noise in the calls. there isn't any echo...
Hi, Are there any cool tools out there that will allow me to perform license capacity management for my Call manager and unity connection. I am looking for something that will provide graphs and display a trend.Thank you
Hi All,I am in the process of integrating a cucm 9.1 cluster with a cuc 9.1 cluster. Some confusing points that i hope can be clarified.for cucm1. I have created one voice mail server with 48 ports that will accomodate both cuc serversfor cucI have...
Hi,Just want to know is there any tool or an application wherein we can create the Voice Diagram for CUCM. Need to have a detail description/flow chart of CUCM Servers, Groups, Region, DP etc. A diagram which clearly briefs about the setup.Pls sugges...
Hi All,Can we integrate two ADs with single call manager cluster?any reference DOC,please share.regds,aman
Hi I need to write translation rule for following requirement original number 28xxxnew number - 09467xxx (replace 28 with 09467, only remove 28 from 5 digit number and add 09467 to it)Please guide Regds$
I have a DID that is not mapped to a user or line. I want any calls placed to that DID forwarded directly to an external number, how would do I go about doing that? Thanks
All,The below is the configuration on our router and we are using Avaya phones on the network .The phones are not receiving dhcp leases and not working ,can anybody suggest what is causing this issue.Building configuration...Curren...
Hello,we are facing a behavior with SIP third Party devices on cucm 8.6.2aSU3The behavior is that in every call the device use the callmanager as MTP to place the call and the RTP stream is always through the callmanager.We would like that the RTP go...
Hi Guys,we have a Cisco US 9 environment. but no physical phone. we only use Jabber.Is there a way to use Jabber to initiate a Meet me conference? RegardsRassoul
I have got 4 Cisco 7960 IP Phones Registered with this Router. I have got 4 SIP Channels. Could anyone suggest any link or configuration to do on this router to make SIP calls. I would like to configure these channels on this router. I have already r...
Dear friends,I am facing prbolem with the calls drop intermitently, below mention is the debug output Dec 3 15:48:35.279 IST: ISDN Se0/1/0:15 Q931: Sending SETUP callref = 0x0087 callID = 0x803F switch = primary-net5 interface = UserDec 3 ...
HiI am trying to configure trusted relay point on a cucm 7 and 9 for Qos Purpose for softphone1)service parameter:Clusterwide Parameters (System - General) sectionFail Call If Trusted Relay Point Allocation Fails: False2) Common Device Configuration ...
All,What commands can you run or how can I can tell if CUBE is running on a Cisco IOS voice router?Adil
Hey i need to upgrade a 7975G phone from sccp to sip. please advice on how to proceed.
