Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I was fresh install CUC cluster (on vCenter but different host machine), when install CUC publisher successfully installed but CUC subscriber failed as below : The installation has encountered a unrecoverable internal error. for further assistance re...
Does CP-7800-WMK Mounting Wall kit is compitabile with 7900 series IP Phones. Also, Does CP-LCKNGWALLMOUNT kit compatible with 7800 series?. Please advise.
Little background: Recently E911 call failed in our environment. CER Pub GUI was not accessible for some reason and Sub was not taking over. Calls went through after restarting both servers from CLI. We found later from TAC that we lost the logs afte...
HiI'm using a remote destination profile. However, when a call is answered on Teams, the desk phone disconnects. This means if I hang up on Teams, I can't resume the call on the desk phone.My setup is as follows:Ribbon as the SBCConnection: Ribbon ->...
Hi! I am looking for the instruction on how to stop having to press the panel button after I hang up after a call. Is there a way to put it normal, like I can just put back the handset in its ^^ place to end a call? Thank you in advance for your supp...
Hello, I'm having an issue getting CUCME running on our Catalyst 8200-1N-4T router and our 8841 IP-Phones. We're running IOS-XE 17.6, and I've attempted manually adding the phone's firmware to the bootflash of our device, yet when I run Router (confi...
I'm looking at our Cisco CUCM (Call Manager) CMR records, and most of the calls show either the same or very similar numbers of packets sent vs received. However a large number of calls show far fewer packets received than sent (can be >50% less). ...
Hello, I am trying to import a user installed certificate into my 7925G cisco IP Phone. I used the following procedure page 98 : http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/cuipph/7925g/7_0/english/deployment/guide/7925dply.pdf I cre...
I have a CUCM 12.5 installation where PSTN calls (through a Spectrum Enterprise SIP trunk) disconnect after 15 minutes. The CUCM connects directly to the telco-provided Audiocodes Mediant SBC. I do not have a CUBE involved in this setup. Attached is ...
is there any way to give statics and ip phone number in cisco pakcet tracer?without configuring dhcp
Hello everyone;I do have a Corporate Directory issue, only on all my 7965 and 7975 phones witch are showing " host not found " message, 6921 are working well.I have in my cluster two CUCM subsribers and one publisher, one of the subscribers is pingab...
I want to achieve the following setup:MS Teams -> SBC -> CUCMThe phone is registered on CUCM with DNs 7666 and 7555.In MS Teams, the DN is +7666.Now, when someone calls from MS Teams (+7666) to 7555, I want the call to ring on the 7666 desk phone as ...
Hello all I've recently purchased a ATA191-3PW-K9 to work with an existing analogue phone. I want to set the IP addressing up so it can connect to my network, however I can't seem to be able to access the webpage via it's default IP address From read...
User wants calls to go to their cell phone but for voicemails to go to Unity Connection.I forwarded his line to his cell phone and made a test call, and I got his cell phone's voicemail.I'm thinking "Mobility" might work differently...Would it leave ...
RTMT version 12.5(001)Is there a way within RTMT to see some sort of a performance monitor that shows if a CTI port has an active call on it?
