IP Telephony and Phones

Hi,I need to upgrade a 5 ccm's cluster. We have around 4000 extension mobility users logged in to their phones.If read the upgrade procedure and seen that it recomentds to stop extension mobility service.I would like to know if after the upgrade, ext...

Hi,First of all, I don't know if it's the correct site to do this question, so, if you think that I hvae to move it I'll do it.The problem we found is that if we make a call with a specific CallerID(name) and CallerID(num) to a phone we see both corr...

Hi allSpeed Dial not appear on phone 9785 and there is button in the phone like Other phones?Thanksakaff

Hi All,Have you guys imported multiple users from exchange to unity by using Bulk Import Exchange, if so please provide me the procedure to add them.I am looking for stunning answer.......

Hi All,We've router 3845 show belowCisco 3845 (revision 1.0) with 219136K/43008K bytes of memory.Processor board ID FHK1319F3BH2 Gigabit Ethernet interfaces124 Serial interfaces6 Channelized/Clear E1/PRI ports2 Voice E & M interfacesDRAM configuratio...

Is there a trick to gettign the NM-HDV-2V to be recognized by the 2821 router?  My IOS  Version 12.4(20)T4.  When I do a "show diag" it says unknown Network Module.

I am trying to configure CUCM 8.03 to use LDAP synchronization and authentication with AD.  The AD server uses LDAP over SSL, so I downloaded the appropriate cert, and went to upload it as a directory trust cert into the CUCM OS Cert mgmt.However, wh...

We are currently running a voice recording and with SIP trunk using the built-in bridge method. At the moment checking the SIP registration is very hard, in RTMT the device>>device search>>>open device search>>>SIP Trunk - only shows the CUCM ip addr...

We recently upgraded from 7.1(2a)SU1 to 7.1(3b) after our licensing TAC case was resolved (too many license files to load before the allotted time causing UCM service to fail completely).  We also upgraded from the default firmware 8.5.2SR1 to 8.5.3 ...

HelloI have a CM 7.1.5 and some 7970 and 7945When I click a Corporate Directory and search a user it appears only the name and number.It is possible when I sync with AD by LDAP to appear the e-mail address, his manager and so on....?It would be great...

Hi,I need to recover SSH and GUI passwords for my client running Call Manager 7.x. I anyone knows about it, please point me to the documentation. Also, if anyone has done it before please advise..I appreciate you help..Thanks..