Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Can someone tell me the difference between two E1 cards in a router - E1 RJ4 and E1 G703- not neccessary the technical stuff just can I use either of them for a 30 Channel E1 link and if so is there a difference in the configuration . I have a spare ...
how can i update the firmware of the pvdm on a 2811 router that have a 12.4(22)T ios.and from where can i download the upgrade software
I'm running a Microsoft OCS R2 connected over SIP to a Cisco2821 running IOS 12.4.24T1 and a CCM running 4.0 connected to the same Cisco2821 over h323. Calls made from a Cisco Phone to OCS works fine, but it's not possible to establish a call from OC...
Hi I have make sip to a service provider in USA but I can't succeed in register. Please refer to the following debug ccsip message. ----------------------------------------001331: Oct 8 10:40:58.319 HK: //-1/xxxxxxxxxxxx/SIP/Msg/ccsipDisplayMsg:Sent...
We have recently gone to CCM 6.1. Extension Mobility (phone logins) seems to take up to 20 seconds or more at times.. Once you enter your userid and password the previous details on the continues to display for at least 20 more seconds before switchi...
Hi ALL!Where I can find parameters which Cisco using in standard cptone RU?These is the following:dualtone busy - what frequency and cadence?dualtone ringback- what frequency and cadence?dualtone disconnect- what frequency and cadence?I can't find it...
I can't find where this is configured - or how to turn it off, but all inbound calls show up with a caller ID prefixed with a 9CUCMBE Version 7.0(3)Any ideas?
I have a lot of 7940Gs and for some reason about 10 out of the 100 we have cannot get past the startup screen. I have done the reset (## 123456789*0#...) but I still cant get past the screen. With the other phones I can simply press the "Settings" ...
Please some one light me do CUCM 7.1 support attend console or we should move only to ARC solution.If the customer is asking attend console functions, eliminating the need for special purpose voice processing hardware, any workaroung is there ? since...
Hi, is it possible to configure a teaming card in the CCM?Or configure the two network ports so that there won'be a network failure for the CCM?If the first network failed, then the communication will pass to the second network.
I'm looking for a simple debug that will log calling/called numbers and time. I am planning on sending this information to my syslog server. What is a good debug for this? Is there a better way to enable simple call logging? TIA.
Hi All, we have a customer with 3COM phone system connected by PRI. they like go with CUCM and integration with 3COM. this is our propose: have 2821 voice gateway with two T1 PRI port. connect one PRI from telco to gateway, and connect second T1 port...
HiWe have to shutdown the Cisco Call Manager (Windows based) and Cisco CRS. Do we need to stop any services or can we just go ahead and shutdown the servers?Thanks
One of my clent asking for 700 IP Phone users with auto attend, I have given BOQ with CUCM 7.1 auto attend solution.Could please some one light more about ARC solution auto attend, what is the benfit we will get if we go for ARC solution. I hope CUCM...
trying to trace smtp messages but i dont have the 'trace' command in my IOS..shouldn't it be part of this IOS (12.4(1r)?
