IP Telephony and Phones

Does anybody know if CM 7.0(1) or 7.0(2) pre-loaded on the new machine from Cisco? Thanks!

Hi,We have CISCO Unified CM 7.0.1 configured with MGCP. We would like to have a welcome message (or Auto Attendant or whatever other names it called) but I don't seem to be able to find it anywhere in the documentation or the interface.Can anyone gui...

Hello,I would like to khnow about the requirement(Hardware and Software)before deploying Cisco Call Manager Auto-Attendant.Thank you in advance

Im pretty sure it's not possible, but I want to have a failback MGCP registration to another cluster if possible. I have an odd setup whereCluster A VG A MGCPCluster B VG B MGCPIs there a way in IOS to configure a failback to each other cluster ...

Hi friends, I installed cisco call manger 6.1 with PRI line.i configure every thing working well and good.i need one backup for pri line so i purchased 4 analog lines .my question is how i need to configure the 4 analog line as a backup line for pri ...

Hi,I need to download 5.1.(3) Reason :the reason is this is the version that I'm running and I need to install a new setup so I will import all data then upgraded to 7.x. But I don't have the cd 5.1(3), is it possible to find that on cisco web site,...

Communications Manager 6.1(3)I'm trying to troubleshoot some call quality issues that we are receiving on inbound calls to 7961s. I know about QRT on the devices? Are there any other tools that comes with CM 6 x that I can use? Thanks very much!

I have Publisher and Subscriber on side A. Now I want to put Subscriber on side B. Side A and Side B connected with 10 Gig interface. Is it normal or I should use new one Subscriber on side B?New Subscriber server costs a lot and I want to know is it...

Has anyone successfully implemented these features using IP versus TDM (PRI) facilities. In this case I would be interested to hear about H.323 to CUBE/GK integrations. Thanks!

I am staging a CUCM 7.x system here in the US that will be shipped to and used in Poland. Anyone have a example of what the route patterns might look like?Thanks in advance for any help.

I have a 2811 router configured as a MGCP gateway to a CUCm 6.0 server. The FXO ports are configured and registered according to CUCM. Inbound call ring the correct port via a "show voice port summary" but it only rings once and then you get dial t...

This is a very simple question but somehow I was not able to get a satifactory answer anywhere.I have a H323 gateway with a voip dial-peer for the destination pattern "25977." and also a ".T" dial peer.When the CallManager routes a call to extension ...

HiI observed a weird behavior on ip phone calls, calls which were transferred to mobile phones disconnected after 1 min.Has anyone encountered this earlier?Thanks.

I have a 6.1 cluster and I would like to add some background images for a few phones.Is there a way to limit those images to only certain phones? Not certain models of phones, but only a few phones?

HiI am configuring H323 GW with CUCM7. Have the required gateway configuration with dial-peer pots:dial-peer voice 100 potsdestination-patter 9Tdirect-inward-dialPort 0/1/0:15Also have the Route pattern configured for international 9.00!. The isdn q9...