Is there any way to configure FAC to be used only on one phone?In other wards,If I have 100 users and each user has his own FAC, if this user try to use his code on other phone he will not be able to place call. He can just place calls from his phone...
Dear All,I have call manager 4.2 and we have integration with Harris pbx 20-20 through PRI E1 using Etsi signal and I tried all "ISDN switch type on voice gateway as net5 ,4ess..." I debugged q931 when i tried all types of isdn switch type but all s...
Hi, I want to setup a Cisco 7945 or IP communicator at home using public IP address to be connected to the CUCM 7 in my office, but I don't want to use VPN. Any step by step help will be appreciated.Thanks
Hi All,We had upgraded from Unity Connection 2. x to UC version 7.0.2.I am unable to leave the message. When I try to call from A to B, B rings for 4 times, then,Phone A dials Voice Mail Pilot Number.Can somebody help on this?regds,aman
hi guys,I have confusion about the Role of Partitions and Calling Search Space at Translation Pattern while call routing ...as per my understanding about Partition in Route Pattern, only those users will access a Route Pattern who would the same part...
If a call comes in on an FXO and I want to ring both an analog phone (on an FXS port) and an IP phone at the same time when this occurs - how to configure this? hunt-group?
I have a WAN-based cluster.site A has Publisher as TFTP server, site A also has a backup TFTP server.SiteB has a subscriber without enabled TFTP service.during normal situation, phones at siteB will registered with SiteB subscriber server while using...
Greeings,I have a customer with several CME deployments and on the 7931 phones the Redial softkey gives me a "not active here" message. It works fine when I am off hook.Phone firmware is 8-3-2-27
I have a customer that I moved over his PRI from an old VG200 that was H323 in/out. The PRI is now connected to a 2811 with MGCP. Everything works fine, but outbound calls I can not get the main number to override some other number that is showin...
HiWe have an integration between CCM6 and Siemens. So, we use one route 50 to use a special lines on Siemens. This works fine.My doubt.On ccm 4.2, we created same speed dials with 50, so when I clicked the speed dial I listen the dial tone and I call...
I am having the following problem with some incoming calls on a Q931 circuit in Germany.If from the UK I dial my customers number which ends 664080xx the called party number presented to the sites 2811 is the full 8 digits meaning the call can be rou...
Hi NetPro - I'm curious, suppose you set up UCM (5.X or above)to connect to MS Exchange UM via a SIP Trunk. When an IP Phone connects to Exchange UM, does the RTP audio stream go directly to the UM server, or does it pass through the CallManager?I'm ...
Hi,I am running cm5.1.3 is there anyway by which i can get detailed report of all the configs done in the callmanager, may be in pdf format which can be good for audit purpose of internal configurations.Thanks inn advance.
