I have a problem, we had a server crash and had to rebuild the subsciber box, unfortunately the cluster password does not appear to be what the previous admin had recorded, How do I reset this so I can get my subscriber server back?
Hi,Recetly there have been a few complaints from users that sometimes when they make calls, the calls just drops out.I then opened CCM traces and I found out that devices are unregistering with the CCM...My event viewver if filled up with these messa...
My topic is quit simple to be honest.I need to know if there is an operational way to import contacts from an Outlook 2003 account to the Personal address book of an Ip phone.My company uses Windows Exchange 2003,CCM 5.1.3 and the ip phones are 797...
I fear there may be a CCM rebuild coming in my near future :).. I'm having a strange problem where I cannot dial internal numbers, that are local to my CCM. Say I have extension 20000, and extension 20001, I cannot dial between the phones. I think...
Need to confirm if the Data Migration Assistant (DMA) is compatible with Callmanager 4.2(3). The cut-off used to be CM 4.1, but I noticed the Compatibility Matrix now shows it as compatible with 4.1, 4.2 and 4.3. Is this accurate?Thanks in advance.
The bigger picture of what I'm doing is trying to ultimately discern what the cause of my "transfer directly to VM" problems are. Along the way, I've decided to try to understand the debug logs in greater detail. In examining them, I have come acro...
Hi, When i receive a call through a MGCP GW QSIG for IP Phone, and IP Phone want transfert to a Phone on traditionnal PABX, i use 2 B Channel.Is there a process to use just one.
I have been looking at backing up Cisco Call manager 5.1 and cisco unity to ensure recovery if we have a failure.I was wondering if anyone had any good docs outlining this process?
I have little problem with my 7921G phones.When somebody calls you, and you press "red button" to reject a call, that call is not actually rejectet, but instead the phone goes to "silent" state. In other states this button works perfect.I have CCME 4...
Hi,I have a router 2821 with ucme 4.2 and phones 7921 and 7920. When the 7921 phones are starting a message show up ih the phone screem "image download failed". The 7920 phones download the image successfully. This is the configuration:tftp-server fl...
Good day to all!I'm trying to find out if Secure SRST is supported on the Cisco 2821 router. I know that normal SRST is supported and that Secure SRST requires a k9 IOS (that I have in place) however the commands are unrecognised when I type them in....
I am going on CME 4.2 and CUE 3.1.1, I want to setup from remote end using Cisco IP phone SIP to register to CME via the Internet.Remote end is using Linksys WRT160N routerNote: No VPN tunnel
Hi,I have a router 2821 with UCME 4.2. When I try to add a phone via GUI a message show me up "no new phone to add!" and I can not finish the task sucessfully. I have tried with auto-reg-ephone and without it.Thanks for your help.Regards
we have two gks(gk1 and gk2). a 3rd gw is going to setup as remote zone. The idea is call through the 3rd gk to gk1 and gk2 will share the use of gk1 and gk2. What command can achieve?I found the statement:remote zone gk1 7* blast/seqremote zone gk2 ...
Guys,Is there any software where you can log onto a web page and look at all your phones that are set to auto-negotiate.This would help a poor man like me from thinking that slow performance could be data infra/circuit/qos related?Help me please, so ...
