Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I've tryed flashing this Skinny version with SIP (tryed 6,7,8 revisions) and all seemed to fail. I even tryed updating to a SCCP version which will support a SIP POS load (Cisco Matrix PDF) and it wouldnt take that load either. Are any of you familua...
My sales people want to forward their desk phone to their cell phones. Some of these phones are long distance. How can I set up the ability to forward their calls to their long distance cells phones?At this point the call will wait for the long dis...
I am having a major issue with a CallManager 5.1.2 install. We are unable to call any CTI Route Points that are configured to forward calls to voice mail. I can also not call forward all to voice mail from any phone. iDivert also isn't working.HELP!!...
I can't get a router to register as a transcoding in CCM 5.1. It keeps coming up saying rejected. I have configured this many times on CCM4.1 without any issues. Did something change?
Is this serverMCS-7835-H1-IPC1supported by Cisco Windows 2000.2.7
Native 6509 with CMM voice module. When upgrade IOS in the supervisor module, does the CMM module auto upgraded, is there a seperate module image for CMM that we apply seperately if need to upgrade CMM for some bug? Thanks
We have a room with 5 ethernet jacks and want to use 15 phones. Is there a way to daisy chain the phones together to make them all functional in an enviroment of jack reduction? If so how can we do this?
Does anyone know what the three Lost counters are for in the "sh call act voice br" command:RRHB-VXR01#sh call act v br | beg 16081608 : 591028919hs.1 +513 pid:1 Answer 2027125556 active dur 00:01:58 tx:5192/103840 rx:5892/117840 Tele 3/1:23:2932499:...
I have an Elevator phone that is looking for 60 ring volts... I tried it on my VG248 and there was not even enough voltage to operate the phone reliably. I now have it connected to an ATA and the phone works without cutting out, however, it doesn't...
Hi;I have a 2-site call manager 4.2.3 cluster. Pub at one site and sub at other with a metroE link between them.Each site has their own gateways and telco pri's.I'm looking for a way to have callmgr automatically reroute a 4-digit site-to-site call o...
I have a CME running for my telephone system. The 48 phones are divided among IP phones and analog phones connected to VoIP gateways (ATA 186).So far i'm able to make calls:Between IP phones (in & out)Between IP phones and analog phones connected to ...
I've been given the task to order POTS lines for inbound and outbound. Will use a 2851 with the VIC2-4FXO. Is their any specific POTS line I have to order or can I say I need 4 POTS lines.Thanks
Can someone send me a link that covers installing and setting up TAPS using CallManager 5.1? Thanks,Chris
Hi, I would like to know the installation and configuration of cisco call manager is i would like to know which course will be helpful for me to go ahead.
I'm trying to figure out what the syntax is for the timeslots for E1 PRI. For T1, it's normally "pri-group timeslots 1-24", but E1 has more B channels and the D channels aren't at the begining of the range, from what I understand;Channel 0 ...
