Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Has anyone successfully inserted a pause in outgoing calls across the PSTN (ISDN) through a dial-peer in CME 4? comma doesn't seem to work when used in the prefix. We're trying to setup to automatically dial into a number, then send dtmf digits af...
Dear Community,I did configure the CallManager (4.2(3)) to dial out via overlap sending (Route Pattern: 0.00! "allow overlap sending" ticked). And the gateway 12.4(8)c as...voice service voip h323 h225 timeout t302 15 h225 signal overlap modem pass...
hi.. what is the common implementation to connect pbx with cisco router? is the connection actualy just by plugging short cable? what necessary frame/signaling needed? i mean something like pri,unframed/framed/channnilized? would please give me under...
hello, I need change logo cisco in me 7912 by company logo.How I can to do this? Thanks.
Hi , how change of dhcp at ip static in 7902 with callmanager 4.2.3 via WEB without using IVR.Can anyone help.Thanks
Our new 7941G's, 7961G's and 7936's have a hard-coded TFTP 49.48.46.50 and 51.46.50.48 value that is not being overriden by the Option 150 tftp address 10.23.205.200Does anyone know how to override the hard-coded behavior? Of course this is affectin...
Hi,I'm reisntalling a publisher CCM due to a hardware problem with the HD. The thing is what should I do first, because I dont't have a backup of the DB, can I get it from the Subscriber and restore in the publisher?Thanks in advance 4 your help.Orla...
Hello,I have CM 5.0 (5.0.4.2000-1) and a number of 7961s with two 7914 expansion modules.When I configure more than 21 BLFs the phone will not register.Has any one else seen this or have I configured something incorrectly?RegardsRay
I have a bad echo on my IP conf phone only even sounds choppey.Any solutions?
I seem to recall 4.1(3) BAT .xls file doesn't pass user validation username with two first or two last names?egLeng Me Wan Firstname,LastnameLeng Me, WanJuan Meo LeeFirstname, LastnameJuan, Meo Lee
Hi,You have to install TAPS on the publisher CallManager and the IPCC Express server. But what about if it's configured for High Availibility (HA)? Do you have to install the TAPS plug-in on both servers or just one?Thanks,Stuart
Hi all,i'm not able to load the network-locale IT and user-local IT on ip phone 7941G-GE.Actually, the ephone has type parameter set to 7941GE, and cnf file are already create (create cnf-file command).All fine with 7940, 7912.... ecc. ecc.Any idea?
I recently got one of these RTMT alerts (sqlservr (95 percent) uses most of the CPU) during a time when there are little if no usage on the phone system. I checked out the event logs and there was nothing during the particular time frame of the RTMT...
I have an ISDN handset connected to a VIC2-2BRI-NT/TE card.Have dial tone and can place calls to other Voip on my system.I have created a dial peer with destination pattern 250.If a call a voip phone it flags the call as comming from 250. If I dial 2...
Hello there,i am working with an 2811 Router with CME and an ATA186 (SCCP firmware) with a HP3392 Fax Machine attached. My Problem is, the the faxes are not always working. It seems that it works by random. The Fax is sometimes transmitted and comple...
