Hi,
I tried to install cucm 4.3, during the installation I faced cisco directory error as the attached photo? anyone have a experience to complete the installation
hello all : I’m trying to upgrade from call manager 4.2 to 11.5 with quantity 250 total and operating the following models (7912,7911,7962,7960) I need to check if I can go through the SKU upgrade through UC-8.X-OR-EARLIER and total UPG-6K-ENH (qty 2...
Hi all,
I have an unknown problem with CME/Voice Gateway CDRs when using file accounting method. I have the primary destination an FTP server and the secondary one to write to Flash.
The first issue is an error message I see in the logging as sho...
hi all
which ios version is the best for cisco router 2811?
in case of using this scenario:
Panasonic TDA100 (PRI 0290) ---> (e1)< cisco 2811> (sip trunk) ----> softx3000
thanks in advance
Hi,
This is my first 12.x build, a new build two server CUCM cluster, i.e. not an upgrade but a new install using the v12 OVA template. CUCM is 12.0.1.22900-11 which is the latest I could find.
We've noticed that the admin web pages are seriously s...
Hi All
I am trying to find the list of unassigned DN within a particular range using AXL or SQL query. Is there a method to find the list. Any help would be much appreciated.
cucm 11.5
we have the following: phoneA with three lines , line1 and 3 same number and different partitions and both in same pickup group
phone B one line and same Pgroup , when I call phoneA line one then im unable to pickup the call using phone B
...
I have to configure auto attendant in CU for callers calling 800#. The 800 number is already forwarded to CTI route point 1000 in CM. I would like the AA to be configured for option to have the caller press 1 to dial by extension if they known it. I ...
Hi , we have situation when users complained that their phones were dialing to operator/main line after they check voicemail. We found out this might be because of users didn't hang up properly with their handset or headsets. Tests confirms, if we do...
I have 2 new Extension Mobility Services I want to add to all the phones in the cluster. Including Device Profiles. I cannot seem to subscribe this service via BAT. What about the check marking the Enterprise Service when creating the IP Phone Servic...
Hello Everyone,
We have a mega CUCM cluster with 21 servers for our multi sites Clustering Over WAN deployment.
Number of site: 20 with different area codes
Number of users: 50000
CUCM Version: 10.5
CUBE (HA): ISR 43xx
Current situation:
Every si...
I have a SIP gateway that works with both inbound/outbound calls. However when I place an outbound call to an external source through the PSTN I can't pass DTMF. In call manager the route pattern sends calls to the SIP gateway via a SIP trunk in ca...
