Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi, When a call is made to 8.XXX.XXXX x1145 from a video phone on the A end in this case an cisco 8865 with x2222. The call establishes with auto attendant on the B end and then presented to the end user at x1145. The B end user picks up the call and...
Hello, We are running CUCM v14. We have several call pickup groups which work fine if the phones are dialed directly. The phones are also in a line group and I want to configure a pickup group on the hunt pilot. The Hunt pilot, pickup group and direc...
CUCM 12.5, I have a Line Group with 3 users, top down then hunt pilot to VM. The RNA Reversion Timeout is set to 15 (per Cisco). One of my users (the first in the line group) sent me a message saying that incoming calls ring to her phone about 10 t...
We are a healthcare facility. For past several months we have had several complaints from users that calls are often full of static. We are running CUCM 12.5(1)SU8 and the phones are primarily 8811 running current firmware. We have replaced phon...
Hi,We have a customer using HCS. As part of this we set up Expressway for them during the first lockdown for them to be able to use Jabber remotely for voice only (no IM&P). They use the same domain name internally and externally e.g. abc.com Another...
Hi all. In the screenshot I encountered a problem: immediately after turning it on, this appears. Has anyone else encountered this problem? It asks for a domain, username and password. The phone is completely new. There is a way to access the setting...
HI, we have project requirement to integrate the Iridium Satellite phone integration with Cisco PABX to make a calls in case of emergency. Can you please suggest, what can we achieved with this interface.1) can we make calls on any number at cisco PA...
Our Forum Alert III Secondary Crash Net (SCN) is inoperable. I've heard the cisco cm could be configured to set up some devices to act as a ringdown, they called it a “Switch Box.” This would allow our Base Operations guys to have a work around from ...
Hi,I am getting the CDR error like below 10021 There are no matching recordsVerified under service parameters , cdr flag enabled True Please helpCUCM 11.5 Thanks
Dear Sir i am new to 8851 ip phone , just need help for speed dial kem i do program speed dial entries into the device and when the phone is turned off the entries are lost is there is any advice why list is forgotten from the phone ? thanks
Hi Experts,I am sitting with an unique issue where my Auto Attendant works perfectly from inside the office, however it is not reachable from external calls.Connection ISP > SIP > CUBE > SIP > CUCMWhat I am seeing is as soon as I direct the call to C...
with ver6.xwhen the operation receive a call from PSTN and transfering to the internal user, on internal user phone, it shown the call from operator, we want to setup shown as the real caller, anyway to enable it?thanks
Hello Cisco-Community ! We actually face a severe problem concerning mostly our cellphone or landline call-in users in WebEx meetings or even conversations from PSTN (mostly vodafone mobile) to normal CUCM SIP registered internal office phones. It ra...
I have a real estate office with a receptionist and a realtor. The realtor phone is set for CallFwdAll to their cell phone. The customer calls into the main number. Then transfer the call to the realtor. The call then get's forwarded to the reatlor's...
We're running into an issue where our agents on a third party contact centre system are experiencing 1 way audio on an intermittent basis roughly around the 15 minutes mark.This is a CUCM v10 solution, connected to said 3rd party contact centre solut...
